diepin A88 Remote Control Instructions

diepin A88 Remote Control

Usage Instructions

Pairing Instructions

• Ensure the remote control is charged.
• Turn on the remote control using the ON/OFF switch.
• On your smartphone or tablet (Android, iOS, or HarmonyOS), go to the Bluetooth settings.
• Search for available devices.
• Select “ADYSS-A88” from the list to pair.
• Once paired, the indicator light may change or stop blinking, indicating a successful connection.

Operating the Remote Control

• Use the Photo button to remotely trigger your device’s camera shutter.
• The remote control has a connection distance of up to 10 meters.

Charging

• Connect a suitable charging cable to the charging port on the remote control.
• Charge the device when the battery is low. The battery capacity is 55mAh.

Troubleshooting

• Device not pairing:
  • Ensure the remote control is turned on and fully charged.
  • Make sure Bluetooth is enabled on your smartphone/tablet.
  • Try restarting both the remote control and your smartphone/tablet.
  • Ensure the remote control is within the 10-meter connection distance.
• Photo button not working:
  • Verify that the remote control is successfully paired with your device.
  • Check if your camera app is open and ready to take a photo.
  • Some camera apps may require specific settings for remote shutter functionality.
• Short battery life:
  • Ensure the device is fully charged.
  • The standby time is 180 days, but continuous use will reduce battery life.

Device Overview

• ON/OFF: Power button.
• Indicator light: Provides status feedback.
• Photo button: Used to trigger camera functions.
• Charging port: For recharging the device.

1. Toggle the switch (ON/OFF) on the back of the remote control, the remote control indicator light will flash automatically.
2. Open the cell phone“ Settings”“- Bluetooth” to open the Bluetooth, search for“ ADYSS-A88” click on the device name pairing, display “Connected”, the indicator light stops flashing, that is, the connection is successful (remote control on state). After the display shows“ connected”, the indicator light stops blinking, that is, the connection is successful (the remote control is turned on).

Product Parameters

• Bluetooth Name: ADYSS-A88
• Main material: ABS plastic
• Support system: Android, IOS, HarmonyOS
• Connection distance: 10 metres
• Product net weight:10g
• Working voltage: 2.8-3.6V
• Working Temperature: -10~50℃
• Battery capacity: 55mAh
• Standby time: 180 days

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure statement

• The device has been evaluated to meel general RF exposure requirement. The device can be used in portable exposure conditions without restriction.