WT101 Remote Control Transmitter
Product Specifications:
- Product Name: Remote Control Transmitter WT101
- Power Source: CR2032 3V battery
- Compliance: FCC radiation exposure limits, ISEDC license-exempt
RSS standard(s) - Warranty: One Year Limited Warranty
Product Usage Instructions:
Mounting the Wall Switch:
- Separate the upper and lower shells of the Wall Switch.
- Install Wall Plate:
- Way1: Secure the lower housing of the wall switch to the wall
using the provided mounting screws. - Way2: Secure the lower housing of the wall switch inside the
wall box using the provided mounting screws.
- Way1: Secure the lower housing of the wall switch to the wall
- Attach the upper shell to the lower shell.
- Attach the transmitter to the base.
- Press the ON/OFF button on the wall switch remote control to
turn the receiver on and off.
Using the Remote Control Transmitter WT101:
- Screw the lamp head to the lamp holder.
- Release the program button, then press the ON button on the
transmitter, and after 1 second, press the OFF button.
Frequently Asked Questions (FAQ):
Q: What battery does the Remote Control Transmitter WT101
use?
A: The Remote Control Transmitter WT101 uses a CR2032 3V battery
for power.
Q: What is covered under the One Year Limited Warranty?
A: The One Year Limited Warranty covers materials and
workmanship from the purchase date. It does not cover damage caused
by personal misuse or improper installation. Please provide your
Order ID and Name for warranty claims.
Q: How far should the equipment be installed from the body for
compliance with radiation exposure limits?
A: The equipment should be installed and operated with a minimum
distance of 20cm between the radiator and your body to comply with
radiation exposure limits.
Remote Control Transmitter WT101
Please pay attention to the warning signs Read the instructions with caution before operating
and keep it properly V30509
Indicator
Please screw the lamp head to the lamp holder.
Release the program button, then press the ON button (1) on the transmitter,and after 1 second, press the OFF button (1).
Mounting the Wall Switch
1.Separate the upper and lower shells of the Wall Switch.
06
Way1
Way2
2.Install Wall Plate Way1: Secure the lower housing of the wall switch to the wall using the
provided mounting screws. Way2: Secure the lower housing of the wall switch inside the wall box
using the provided mounting screws.
3.Attach the upper shell to the lower shell.
7
4.Attach the transmitter to the base.
5.Press the ON/OFF button on the wall switch remote control to turn the receiver on and off. CR2032 3V
08
CR2032 3V
100
60
100 CR2032 3V
09
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
ISEDC Warning: This device complies with Innovation, Science, and Economic Development Canad licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’ Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil nedoit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Ce matériel est complétépar une exposition de rayonnements ISED pour un environnement naturel. Ce matériel doit être installéet se faire avec une distance minimale de 20cm entre les radiateurs et les autresYour body shop.
10
One Year Limited Warranty Supported by our professional R&D team and QC team, we provide One Year Warranty for materials and workmanship from the purchase date. Please note that the warranty does not cover damage caused by personal misuse or improper installation. Please attatch your Order ID and Name so that our dedicated customer service team can help you better.
11
Documents / Resources
 |
dewenwils WT101 Remote Control Transmitter [pdf] Instruction Manual 023, WT101 Remote Control Transmitter, WT101, Remote Control Transmitter, Control Transmitter, Transmitter |
