Installation Guide for HOOKE ROAD models including: BXG.9460, BXG.9460 Front Bumper, Front Bumper, Bumper
Hooke Road Bumper Installation Instructions | Installation Manual – Hooke Road 4x4
MAKEA DIFFERENCE Fr ont Bum per BXG.9460 (INSTALLATION INSTRUCTION) Please verify all parts are present and read instructions carefully before starting installation. Please feel free to contact your distributor if you have any kind of question about your purchase. 1 CONTENTS Left Right A B C1 C2 D1 D2 A: Bull Bar B: Main Body C1&C2: Wings D1&D2: License Plate Bracket Qty Part Name 6 Hex Bolt Size(mm) M12*30 Picture Qty Part Name 4 Flat Washer Size(mm) M8 Picture 4 Hex Bolt M8*20 4 Flat Washer M6*12*1 4 Button Bolt M6*16 2 Nylon Round Spacer M6*12*1.3 8 Button Bolt M4*20 6 Split Lock Washer D12 4 Split Lock Washer D8 6 Flat Washer M12*30*1.5 6 Hex Nut M12 4 Flange Hex Lock Nut M8 4 Nylon Lock Nut M6 1 L-Wrench M4 4 Sensor Bracket 2 TOOLS REQUI RED Drive Ratchet Handle 10mm, 14mm Wrench 4mm Hex Bit Socket 17mm, 19mm Wrench To view online instruction, please scan the QR code. 3 I NSTALLATI ON I NSTRUCTI ON Place the vehicle in park, remove the factory bumper from the frame. St ep 1 2 1 St ep 2 Remove the factory sensors from the factory bumper. Install it to the bumper using the (8) M4x20mm button bolts. 1 2 3 4 St ep 3 Install the left wing to the main body using (3) M12x30mm hex bolts, (3) D12 lock washers, (3) M12x30x1.5mm flat washers, (3) M12 hex nuts. Repeat this step for the opposite of the bumper. Tighten up all bolts. St ep 4 Install the bull bar to the main body using the (4) M8x20mm hex bolts, (4) D8 lock washers, (4) M8x20x2mm flat washers, (2) M8 flange lock nuts. Tighten up all bolts. St ep 5 Assemble the license plate brackets using the (2)M6x16mm button bolts, (2) M6x12x1mm flat washers, (2) M6x12x1.3mm nylon round spacer, (2) M6 nylon lock nuts. Install the assembled license plate bracket to the bumper using the (2)M6x16mm button bolts, (2) M6x12x1mm flat washers, (2) M6 nylon lock nuts. Tighten up all bolts. St ep 5 St ep 6 Install the bumper to the vehicle using the factory nuts. Repeat this step for the opposite of the bumper. Adjust the bumper to the desired location. Tighten up all bolts. 1 St ep 7 The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product! to find your parts. Feel Free To Share Your Vehicle @HookeRoad4x4 With The Hashtag #hookeroad If You'd LikeAdobe Illustrator 28.0 (Windows) iLovePDF