KODAK M35 35mm Film Camera Instruction Manual

Einführung

This manual provides essential instructions for the proper use and care of your KODAK M35 35mm Film Camera. Please read this manual thoroughly before operating your camera to ensure optimal performance and longevity.

Kamerakomponenten

Familiarize yourself with the main parts of your KODAK M35 camera.

Abbildung 1: Vorderseite View. This image shows the front of the Kodak M35 camera, highlighting the lens, viewfinder, and flash unit. The camera body is purple.

Abbildung 2: Zurück View. This image displays the rear of the Kodak M35 camera, showing the film counter window, film advance wheel, and film rewind crank slot.

Abbildung 3: Oben View. This image illustrates the top of the Kodak M35 camera, featuring the shutter button and film advance wheel.

Aufstellen

1. Einlegen der Batterie

The KODAK M35 requires one AAA battery (not included) to power the built-in flash. Film operation is mechanical and does not require battery power.

1. Suchen Sie die Abdeckung des Batteriefachs an der Seite oder Unterseite der Kamera.
2. Schieben oder öffnen Sie den Deckel.
3. Legen Sie eine AAA-Batterie ein und achten Sie dabei auf die richtige Polarität (+/-), wie im Batteriefach angegeben.
4. Schließen Sie den Batteriefachdeckel fest.

2. Film einlegen

The KODAK M35 uses 135 film (35mm film). Ensure you use film with an ISO of 200 or 400 for best results.

1. Open the camera back by sliding the latch downwards (usually on the side of the camera).
2. Place the new 35mm film canister into the film chamber on the left side.
3. Ziehen Sie das Filmende zur Aufwickelspule auf der rechten Seite. Führen Sie die Spitze des Filmendes in einen der Schlitze der Aufwickelspule ein.
4. Drehen Sie das Filmtransportrad leicht, um sicherzustellen, dass der Film fest mit der Aufwickelspule und den Zähnen des Transportrads verbunden ist.
5. Schließen Sie die Kamerarückseite fest, bis sie einrastet.
6. Advance the film by rotating the film advance wheel and pressing the shutter button twice to wind past any exposed film. The film counter should show '1' after this process.

Figure 4: Film Loading. This image shows the back of the Kodak M35 camera with the film door open, illustrating the film chamber and take-up spool for loading 35mm film.

Bedienungsanleitung

1. Ein Foto machen

The KODAK M35 is a focus-free camera, simplifying the picture-taking process.

1. Schauen Sie durch die viewSucher, um Ihre Aufnahme einzurahmen.
2. Press the shutter button located on the top of the camera to take the picture. The shutter speed is fixed at 1/120 second.
3. After taking a photo, manually advance the film by rotating the film advance wheel until it stops. This prepares the camera for the next shot and updates the film counter.

Figure 5: Framing a Shot. This image highlights the lens and viewfinder on the front of the Kodak M35 camera, used for composing photographs.

2. Verwendung des eingebauten Blitzes

The KODAK M35 features a built-in flash for low-light conditions. The flash requires a AAA battery to operate.

1. To activate the flash, slide the flash switch (usually on the front or top of the camera) to the 'ON' position.
2. Wait for the flash ready indicator light (often red) to illuminate, indicating the flash is charged and ready to fire. This may take a few seconds.
3. Once the indicator light is on, take your photo as usual.
4. Remember to turn off the flash when not needed to conserve battery life.

3. Rewinding and Unloading Film

Once all exposures on the film roll have been used, the film must be rewound back into its canister before opening the camera back.

1. Suchen Sie die Filmrückspultaste (normalerweise an der Unterseite der Kamera). Drücken und halten Sie diese Taste.
2. While holding the rewind button, turn the film rewind crank (located on the top or side of the camera) clockwise until you feel the tension release, indicating the film is fully rewound into the canister.
3. Release the rewind button.
4. Open the camera back and remove the film canister.
5. Take the exposed film to a photo lab for development.

Figure 6: Film Rewind. This image shows the side of the Kodak M35 camera, indicating the location of the film rewind crank for manually rewinding exposed film.

Wartung und Pflege

• Handhabung: The KODAK M35 camera is constructed from plastic. Handle it with care to prevent damage from drops or impacts.
• Reinigung: Use a soft, dry cloth to clean the camera body. For the lens and viewfinder, use a specialized lens cleaning cloth and solution. Avoid abrasive materials or harsh chemicals.
• Lagerung: Store the camera in a cool, dry place away from direct sunlight and extreme temperatures when not in use. Remove the AAA battery if the camera will not be used for an extended period to prevent leakage.
• Film: Always store film in a cool, dry environment. Avoid exposing film to X-rays at airports; request a hand inspection.

Fehlerbehebung

Technische Daten

• Filmformat: 135 Film (24 x 36 mm)
• Film ISO: Compatible with ISO 200 / 400
• Optiklinse: 31 mm, F=10, 1 Element
• Fokussierung: Focus Free, 1M to ∞ (Infinity)
• Verschlusszeit: 1 / 120 s
• Filmtransport: Manueller Vor- und Rücklauf
• Blitz: Built-in Flash (requires 1x AAA battery)
• Abmessungen (L x B x H): 4.49 x 2.48 x 1.38 Zoll (114 x 63 x 35 mm)
• Gewicht: 4.7 Unzen (132 Gramm)

Garantie und Support

For warranty information and customer support, please refer to the documentation provided at the time of purchase or contact the manufacturer, Sino Promise Group, or your retailer. KODAK is a registered trademark used under license.