Module CAP10CNC
USER GUIDE FOR MODULE
CAP10CNC
FEB-2020
This document is applied for the following products
Module CAP10CNC
Specification
| Output | 4-20mA output (with 250 ohms precision resistor), or RS485/ModbusRTU |
| Power supply | 8..50VDC |
| Consumption | max 35mA |
| Capacitance range | 0-400 pF |
| Working temperature | -40 oC .. + 85 oC |
Instructions for configuration
3.1 Wiring
Please wiring as shown below:
3.2 Soldering wire connected to input C signal
- Solder the signal C to the middle point of the circuit.
- Choose 1 of 3 points on the edge of the circuit (1 or 2 or 3) to connect GND.
3.3 Calibration
Zero: Power the circuit, press the button 3 times consecutively then wait for the LED to blink continuously, we will press one more time. Disconnect power.
Full-scale: Power the circuit, press the button 3 times consecutively then wait for the LED to blink continuously, we will hold the button, when the light is off we take our hands off.
Documents / Resources
 |
daviteq CAP10CNC Module [pdf] Instructions CAP10CNC, CAP10CNC Module, Module |