datamax-oneil Static Brush Installation Guide

datamax-oneil Static Brush Installation Guide

Installation Instructions

  1. Turn ‘Off’ and unplug the printer.
  2. Open the cover. Using the illustrations below, locate the area where the Static Brush will be installed.
  3. Using a Cotton Swab or cloth, moistened with isopropyl alcohol, gently clean the surface where the Static Brush will be installed.
    Warning Icon
    WARNING

    Isopropyl alcohol is a flammable solvent; always take the proper precautions when using this substance.
  4. Peel the backing from the adhesive strip on the back of the Static Brush and affix the brush to the printer in the location shown in the below illustrations.

Note Icon Note: The Static brush should be installed so the bristles are as close to the ribbon without actually touching. It may be necessary to install a roll of ribbon in order to properly align the brush to the ribbon.

M-Class Printers
Note Icon Note: For M-Class printers, the Static Brush must be cut to length in order to fit properly.

M-Class Printers

I-Class Printers

I-Class Printers

H-Class Printers 

H-Class Printers

Documents / Resources

PDF thumbnailStatic Brush
Installation Guide · Static Brush, Brush

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.