DASH Multi Maker Mini Maker
Before First Use
Installing The Removable Plates
Choose two Removable Plates for cooking. Install the Removable Plates by sliding them into the two open slots located at the top and bottom of the MultiMaker™ (photo A).
Each Removable Plate is labeled either “Top” or “Bottom.” Slide each Plate into its respective slot.
Push down at the corner where the plate is labeled “Top” or “Bottom” until there is a slight click indicating that the Plate is properly in place (photo B).
Cooking with the MultiMaker™ Mini Maker
To make a mini imprint waffle, use 1.5 tablespoons of batter. For a 4″ circular waffle with the imprint, use 3-4 tablespoons of batter.
Removing The Plates
To remove the Plates, press the corresponding Release Tabs inside the Handle [there’s one at the bottom (photo A) and one at the top (photo B).] After pressing the Release Tab, lift and slide the Plate out.
CAUTION: Always lift and lower the Cover Handle from the right side to avoid hitting the Release Tab.
Documents / Resources
 |
DASH Multi Maker Mini Maker [pdf] Instructions Multi Maker Mini Maker, Maker Mini Maker, Mini Maker, Maker |