Danfoss ECA 20 Remote Control Units
Product Specifications
- Product Name: ECA 20, Web Panel for ECL Apex 20
- Manufacturer: Saia-Burgess
- Type: PCD7.D457STCF
- Code Number: 087B2504
- Connections:
- USB
- Ethernet
- Inter-connections:
- RS232
- PS/2
- RS485
- Power Supply: 24V DC
Installation Guide
Follow the steps below to install the ECA 20 Web Panel:
- Connect the necessary cables to the designated pins according to the provided pinout.
- Ensure proper wiring connections as specified in the manual.
- Power the device using a 24V DC power supply.
- Refer to the manufacturer’s website or YouTube channel for additional installation videos and guides.
Connection Setup
Connect the ECA 20 Web Panel to your system using USB and Ethernet connections. Follow the pinout diagram for correct pin connections.
- Pin_1 : DCD Pin_6 : DSR
- Pin_2 : RX Pin_7 : RTS
- Pin_3 : TX Pin_8 : CTS
- Pin_4 : DTR Pin_9 : do not use
- Pin_5 : GND
Inter-connections
Utilize the RS232, PS/2, and RS485 ports for interconnecting the ECA 20 Web Panel with other devices. Ensure proper grounding and power supply connections.
Wiring
- ECA 20: www.heating.danfoss.com
https://www.youtube.com/user/Danfoss->Heating->Playlists->How-to-Videos->District Energy installation videos
Danfoss A/S
- Heating Segment
- danfoss.com
- +45 7488 2222
- E-Mail: heating@danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss and all Danfoss logotvoes are trademarks of Danfoss A/S. All riahts reserved.
FAQ
Q: Where can I find more information about the ECA 20 Web Panel?
A: Visit the manufacturer’s website at www.heating.danfoss.com or check their YouTube channel for how-to videos and installation guides.
Q: What power supply voltage is required for the ECA 20 Web Panel?
A: The ECA 20 Web Panel requires a 24V DC power supply for operation.
Documents / Resources
 |
Danfoss ECA 20 Remote Control Units [pdf] Installation Guide ECA 20 Remote Control Units, ECA 20, Remote Control Units, Control Units, Units |