Danfoss AK-XM 101A Transmitter Fault Detection
Specifications
- Model: AK-XM 101A
- Model: AK-XM 205A
- Model: AK-XM 205B
- Part Number: 080R9226 AN00008642722201-000601
- Resistor: 47 kohm AKS 32R
Installation Guide
- When using AKS 32R, it should be connected to the controller module. If it is connected to an extension module, the enclosed resistor must be mounted to ensure the proper detection of any sensor errors.
Fault Detection
If an AKS 32R is to transmit a signal to two, three, four or five extension modules only two resistances have to be connected – one at either end of the signal.
Compatibility
- The resistances are left out if the remaining controllers are of another type.
FAQs
What should I do if I encounter sensor errors?
Ensure that the AKS 32R is properly connected to the controller module and that the enclosed resistor is mounted if using an extension module for accurate sensor error detection.
Documents / Resources
 |
Danfoss AK-XM 101A Transmitter Fault Detection [pdf] Installation Guide AK-XM 101A, AK-XM 205A, AK-XM 205B, AK-XM 101A Transmitter Fault Detection, AK-XM 101A, Transmitter Fault Detection, Fault Detection |