AK-SM 850A Temperature Recorders Control and Monitoring
AK-SM 800A
-10 °C< tamb < 50 °C 14 °F < tamb < 120 °F 0 95% RH, IP20
Danfoss 80Z817
AN307930531782zh-000201
Listed UL E31024 61B5 NEC Class 2 LPS 16 AWG 75 °C (167 °F) 1 FCC ID : X02SPB209A IC ID : 8713A-SPB209A CMIIT ID : 2021AJ8491 (AK-SM 820A)
2021AJ8486 (AK-SM 850A) 2020AJ8467 (AK-SM 880A)
43mm
mm mm
Danfoss 80Z818
mm T 8
mm
1 2
T10
LON-
MODBUS 1
100 – 240 V AC Rela1y/12/2 Canbus Ethernet 00 MODBUS 1/2 LON / TP78
MODBUS 2
LON
100 240 V AC
Canbus
CAN bus
()
TP 78-version
MODBUS 1 MODBUS 2 (Danfoss) (RS485)
TP 78 LON 1
TP 78 LON 2
TP 78 LON 3
TP 78 LON 4
© Danfoss | Climate Solutions | 2024.10
AN307930531782zh-000201 | 1
“ADAP-KOOL® ” = RC8AC901 ()
RC8AC902 () RC8AC903 () RC8AC904 () RC8AC907 ()
Out
120
MODBUS LON TP78 Canbus
Systemunit=
120-ohm100 130 ohm
Repeater STeyrsmteinmatuionnit== 112200
WiFi
Danfoss 80Z819
Danfoss 80Z820
0 (WAN) 1
1. WiFi 2.
2 | AN307930531782zh-000201
© Danfoss | Climate Solutions | 2024.10
AK-SM 820A AK-SM 850A AK-SM 880A
0 = 1 – 9 =
AK-SM 800
1. 2. 3. 4. / 5. 6. 7.
BC316842192932en-001001
SOFTWARE UPDATE
1 ak-sm800a.danfoss.com
2 Web
© Danfoss | Climate Solutions | 2024.10
AN307930531782zh-000201 | 3
Statements for the AK-SM 800A
FCC COMPLIANCE STATEMENT CAUTION: Changes or modifications not expressly approved could void your authority to use this equipment This device complies with Part 15 of the FCC Rules. Operation to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
INDUSTRY CANADA STATEMENT This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
NOTICE
FCC COMPLIANT NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Modifications: Any modifications made to this device that are not approved by Danfoss may void the authority granted to the user by the FCC to operate this equipment.
Any regulatory related concerns contact: global_approvals@danfoss.com
Danfoss Cooling 11655 Crossroads Circle Baltimore, Maryland 21220 United States of America global_approvals@danfoss.com www.danfoss.com
EU CONFORMITY NOTICE Hereby, Danfoss A/S declares that the radio equipment type AK-SM 800A is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.danfoss.com
Danfoss A/S Nordborgvej 81 6430 Nordborg Denmark global_approvals@danfoss.com www.danfoss.com
The Product contains electrical components And may not be disposed together with domestic waste. Equipment must be separate collected with Electrical and Electronic waste. According to Local and currently valid legislation.
ADAP-KOOL®
4 | AN307930531782zh-000201
© Danfoss | Climate Solutions | 2024.10
Documents / Resources
![]() |
Danfoss AK-SM 850A Temperature Recorders Control and Monitoring [pdf] Instruction Manual AK-SM 850A, AK-SM 850A Temperature Recorders Control and Monitoring, Temperature Recorders Control and Monitoring, Recorders Control and Monitoring, Control and Monitoring, Monitoring |