Produkt overview
The RYOBI 25cc Gas Jet Fan Blower is a powerful handheld tool designed for efficient clearing of leaves, grass, and debris. It features a 2-cycle engine, jet fan design, variable speed trigger, and cruise control for optimal performance and user comfort.
- Motor: 25cc Gas, 2-Cycle
- Lufthastighed: Op til 160 MPH
- Luftvolumen: 520 CFM
- Funktioner: Jet Fan Design, Variable Speed Trigger, 3-Position Cruise Control, Anti-Vibe Handle
- Formfaktor: Håndholdt
Opsætning og montering
Udpakning og indledende inspektion
Carefully remove all components from the packaging. Inspect for any damage. Ensure all parts listed in the packing list are present.
Monteringsvejledning
- Fastgør blæserrør: The blower tube typically comes in multiple sections. Align the sections and push them together until they securely click into place. Some models may use clips or screws for additional security.
- Install Control Handle (if applicable): If your model includes a separate control handle for the blower tube, attach it to the designated slot on the tube. Ensure it is firmly secured and allows for comfortable operation.
- Connect Flexible Hose (if applicable): For models with a flexible hose connecting the engine unit to the blower tube, attach the hose securely to both ends using the provided clamps.
Brændstofforberedelse
This RYOBI blower uses a 2-cycle engine and requires a specific gasoline-to-oil mixture. Refer to the fuel tank cap or the engine label for the exact ratio. A common ratio for 25cc 2-cycle engines is 25:1 or 40:1. Always use fresh, unleaded gasoline with an octane rating of 89 or higher and a high-quality 2-cycle engine oil.
- Bland benzin og totaktsolie i en separat, godkendt brændstofbeholder.
- Ryst beholderen grundigt for at sikre korrekt blanding.
- Do not mix fuel directly in the blower's fuel tank.
Fueling the Blower
- Placer blæseren på en plan overflade.
- Rengør området omkring tankdækslet for at forhindre snavs i at trænge ind i tanken.
- Fjern forsigtigt brændstofdækslet.
- Pour the prepared fuel mixture into the fuel tank using a funnel to avoid spills.
- Overfyld ikke. Sørg for plads til brændstofudvidelse.
- Sæt brændstofdækslet sikkert på igen.
Betjeningsvejledning
Starting the Engine (Cold Start)
- Spæd motoren: Press the primer bulb 10 times until fuel is visible in the return line.
- Indstil choker: Flyt chokerhåndtaget til positionen LUKKET.
- Indstil hastighedskontrol: Push the speed control lever all the way forward.
- Træk i startsnoren: Place the blower on a flat, stable surface. Hold the blower firmly with one hand and pull the starter rope until the engine attempts to start (you may hear a puff noise). Do not pull more than 3 times.
- Juster chokeren: Move the choke lever to the MIDDLE position.
- Genstart motor: Pull the starter rope again until the engine fully starts and runs.
- Opvarmning: Let the engine run for approximately 10-30 seconds.
- Open Choke: While fully squeezing and holding the trigger, move the choke lever to the OPEN or OFF position.
- Final Warm-up: Allow the engine to run for an additional 1 minute to fully warm up before use.
Brug af blæseren
- Trigger med variabel hastighed: Control the air speed by adjusting the pressure on the trigger.
- Fartpilot: Engage the 3-position cruise control for continuous operation at a desired speed without holding the trigger.
- Anti-vibrations håndtag: The anti-vibration handle with overmolded grips is designed for optimized user comfort during extended use.
Opretholdelse
Regelmæssig kontrol
- Luftfilter: Regularly inspect and clean the air filter to ensure proper engine performance and prevent overheating. Replace if damaged.
- Tændrør: Check the spark plug periodically for wear and carbon buildup. Clean or replace as needed to ensure easy starting and efficient combustion.
- Brændstofledninger: Inspect fuel lines for cracks or leaks. Replace any damaged lines immediately.
- Generel rengøring: Keep the blower's air intake and exterior free of debris to maintain optimal airflow and prevent engine strain.
Opbevaring
- Ved langtidsopbevaring skal alt brændstof tømmes fra tanken og motoren køres, indtil den stopper, for at rense karburatoren.
- Rengør blæseren grundigt før opbevaring.
- Opbevares tørt og godt ventileret, væk fra direkte sollys og ekstreme temperaturer.
Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Motoren vil ikke starte | Intet brændstof eller forkert brændstofblanding | Fill tank with correct 2-cycle fuel mixture. |
| Tændrøret er snavset eller vådt | Rengør eller udskift tændrøret. | |
| Chokeren er ikke indstillet korrekt | Follow cold start procedure. | |
| Tab af magt | Tilstoppet luftfilter | Rengør eller udskift luftfilteret. |
| Gammelt eller forældet brændstof | Drain old fuel and refill with fresh mixture. |
Specifikationer
- Mærke: RYOBI
- Model: BLÆSER
- Motorvolumen: 25cc
- Motortype: 2-taktsgas
- Maksimal lufthastighed: 160 MPH
- Maks. luftmængde: 520 CFM
- Strømkilde: Gasdrevet
- Formfaktor: Håndholdt
- Særlige funktioner: Jet Fan Design, Variable Speed Trigger, 3-Position Cruise Control, Anti-Vibe Handle
- UPC: 659821583744
Produktmedier
Produktbilleder
Officielle produktvideoer
Garanti og support
For garantioplysninger, teknisk support eller bestilling af reservedele henvises til den officielle RYOBI webwebstedet eller kontakt kundeservice direkte. Gem din købskvittering som købsbevis.
- Kundeservice: Refer to your product packaging or the official RYOBI webwebsted for kontaktoplysninger.
- Online ressourcer: Visit the RYOBI website for additional manuals, FAQs, and product registration.
