CYCMOTOR X6 Controller Upgrade Kit

Requirements

To upgrade from the ASI BAC855 to the CYC X6 Controller, the follow components are required for conversion:

• X6 Controller
• Wire Cover Plate
• Bluetooth Speed Sensor & Magnet
• Speed Sensor Magnet
• SW102/ DS103 Display (optional)

Please note that the sptes and images used in the below guide are for reference only. We strongly encourage you to email technical_support@cycmotor.com if you are uncertain about any of the steps described below.

CYC X6 Controller Upgrade Kit Guide

1. STEP 1:
   Unplug the phase wires (yellow, blue, red), torque sensor wire, motor wire & XT90 connector from the BAC855 controller mount.
2. STEP 2:
   Unscrew the BAC855 controller mount bolts from both sides and remove the controller & controller mount to install the X6 controller.
3. STEP 3:
   Plug in the phase wires (yellow, blue, (green = red)) & insert the torque sensor wire, motor wire, XT90 connector at the back of the controller mounting plate.
4. STEP 4:
   Gently bend all the wires, and the house them inside the controller housing, then tighten all the bolts on the controller mount.
   And finished! As mentioned prior, kindly contact technical_support@cycmotor.com if further assistance is needed. Thank you!.
5. STEP 5:
   Tighten the bolts according to the kit you have as follows. (X1 Pro, M5 Bolts = red circle, X1 Stealth, M4 Bolts = green circle).

support@cycmotor.com
+852 3690 8938

Documents / Resources

CYCMOTOR X6 Controller Upgrade Kit [pdf] User Guide BAC855 old controller, X1 Pro for M5 bolts, X1 Stealth for M4 bolts, X6 Controller Upgrade Kit, Controller Upgrade Kit, Upgrade Kit

References

• User Manual