cudy GS1008PS2 8 Port Switch Installation Guide

Default Extend: Common mode for all interfaces with a transmission distance of less than 100 meters at adaptive rates.
Link Extension: Force 10M on ports 7-8 for link extension up to 250M (enable POE watchdog).

LED and Interface Explanation

PWR LED: Indicates power status.

1-10 Green Light (Link&Data):
- ON: Link normal
- OFF: Link blocked
- Flashing: Data transmitting

Hardware Connection

Physical Appearance

Specifications

Model
GS1008PS2
PoE Standard
IEEE802.3 / IEEE802.3u

POE port output
IEEE802.3x / IEEE802.3af/at
PoE Protocol
IEEE802.3at (30W) and IEEE802.3af (15.4w)

Output
Power over spare pairs 1/2(+) , 3/6 (-)
Input Voltage
AC 100-240 V 50-60Hz

Supply Power
52V ~ 2.3A
Total Power
120W

Dimension(L×W×H)
220mm*161mm*44mm
Bandwidth
20Gbps

Pack forward rate
14.88Mpps
Memory cache
448Kb

MAC address
2K
Jumbo Frame
9216bytes
Working Environment
- Working Temperature: -10~50°C
- Storage Temperature: -40~70°C
- Working Humidity: 10%~90%, non-condensing
- Storage Temperature: 5%~90%, non-condensing

DIP Explanation

LED and Interface Explanation

FAQ (Frequently Asked Questions)

Q: Where can I find the EU declaration of conformity for the GS1008PS2?
A: The original EU declaration of conformity can be found at www.cudy.com

Q: How can I contact support for the GS1008PS2?
A: You can reach out to support via email at support@cudy.com

Q: What are the power input requirements for the GS1008PS2?
A: The GS1008PS2 requires an AC input of 100V-240V at 50-60Hz.

EU declaration of conformity
Cudy hereby declares that the device is in compliance with the essential requirements and other relevant provisions of directives 2014/30/EU, 2014/35/EU, 2009/125/EC and 2011/65/EU.The original EU declaration of conformity may be found at http://www.cudy.com/

Email: support@cudy.com

www.cudy.com