T5F0 Low Cost TFT LCD Display
Informace o produktu
Specifikace
- Main Chip: T5F0 ASIC
- User Interface: DGUS II
- Rozlišení: 480 × 480 pixelů
- Screen Size: 2.1-inch IPS TFT LCD
- Interface: 20 pins including UART2, SD card, Buzzer, touch
panel interface - Supported Touch Panels: 4-wire RTP, CTP
- Backlight Service Life: >10,000 hours
- Brightness: 300nit with 100-level brightness adjustment
Návod k použití produktu
Napájení a připojení
1. Connect the +5V pin to the power supply (+5V).
2. Connect the GND pins to the ground (GND).
3. Ensure the power supply is within the range of
DC4.5-5.5V.
Připojení rozhraní
1. Connect UART2 for communication.
2. For SD card interface, ensure JIOS is not connected (in the
vzduch).
3. Connect the touch panel interface pins for touch
funkčnost.
Rozhraní dotykové obrazovky
1. For resistive touch screens, connect the necessary pins for
přenos dat.
2. For capacitive touch screens, ensure CIP_SDA and CTP_INT are
pulled up to 3.3V using a 4.7K resistor.
Zvukový výstup
1. Use the buzzer or speaker for audio output.
2. Ensure proper connections for audio PWM DA output.
Často kladené otázky (FAQ)
Otázka: Jaký je doporučený napájecí zdroj objtage?
A: The device operates best within a DC4.5-5.5V range for stable
výkon.
Q: How to adjust screen brightness?
A: Use the brightness control feature with 100 levels of
adjustment. Avoid using below 30% brightness to prevent
blikající.
Q: How to prevent screen burn-in?
A: Use dynamic screen savers to prevent afterimages from
prolonged fixed page display.
Profesionální, důvěryhodný, úspěšný
DMG48480F021_05WN_ Product Specification
DMG48480F021_05WN
T5F0 ASIC DGUS II 2.1 480*480 IPS 20 pin 2SD 4 RTPCTP
Vlastnosti:
Powered by T5F0 ASIC, running DGUS II HMI platform. 2.1-inch, 480*480 resolution, IPS-TFT LCD, Circular LCD screen.
20 pins, including UART2, SD card, Buzzer, touch panel interface.
Supporting connected to 4-wire RTP, CTP, buzzer or speaker.
www.dwin.com.cn
1
400 018 9008
Profesionální, důvěryhodný, úspěšný
1 External Interface
DMG48480F021_05WN_ Product Specification
KOLÍK#
1
2 3 4 5
6
7 8 9 10 11 12 13 14 15
16
17
18
19
20
Uživatelské rozhraní
Definition1 1 +5V
+5V GND GND GND
3.3V
TX2 RX2 SD_D0 SD_D1 SD_D2 SD_D3 SD_CLK SD_CMD TPY1
TPX1
TPY0
TPX0
JIOS
BZUČET
Funkce1
1
DC4.5-5.5VIO 3.3V CMOS Power supply, DC4.5-5.5V. IO are all at 3.3V CMOS level.
Definition2 2
GND
3.3V 100mA 3.3V output, maximum load of 100mA. UART2
JIOS SD When JIOS is in the air, SD card interface.
4 4-wire resistive touch screen interface
JTAG/IO JTAG/IO choose Buzzer drives output
TMS TCK TDI TDO TX1 RX1 CIP_SDA CTP_INT CTP_SCL CTP_RST
D/A
Function2 2
JIOS JTAG When JIOS is shorting circuit to ground, JTAG rozhraní.
UART1 Multiplexed UART1 CTP CIP_SDACTP_INT 4.7K 3.3V Capacitive touch screen interface When connected to CTP, the CIP_SDA and CTP_INT need to be pulled up to 3.3V by an external 4.7K resistance.
PWM DA Audio PWM DA output
www.dwin.com.cn
2
400 018 9008
Profesionální, důvěryhodný, úspěšný
2 Specification Parameters
DMG48480F021_05WN_ Product Specification
2.1 Product Parameters
Hlavní čip
Uživatelské rozhraní
T5F0 20Pin_0.5mm FCC
BLIKAT
16 MB
UI UI Version
DGUS II
Napájení
HDL662SZ5 HDL662SZ5 adapter board power supply
Rozměry
2.1 2.1-inch
Rezoluce
480*480
Active Area (AA)
=53.28mm Diameter=53.28mm
Viewúhel
Životnost podsvícení
85°/85°/85°/85°) Wide viewing angle (85°/85°/85°/85° typical), high contrast, and good color reproduction.
>10,000H
Jas
300nit
100 1%~30%
Ovládání jasu
100-level brightness adjustment (Flickering may occur at 1%-30% of
max brightness; not recommended for use in this range)
Note: Use dynamic screen saver to prevent afterimages from prolonged fixed page display.
www.dwin.com.cn
3
400 018 9008
Profesionální, důvěryhodný, úspěšný
2.2 Interface Parameters
Položka
přenosová rychlost
Podmínky
User Set(Configure the CFG file)
Výstupní objemtage(TXD)
Výstup 1 Výstup 0
min 3150
3.0
–
Typ
115200
3.3
0
Vstupní objemtage(RXD)
Vstup 1 Vstup 0
–
–
0
–
Rozhraní
UART2: TTL
Formát dat
UART2: N81
2.3 Electrical specifications
Jmenovitý výkon
<2W
Provozní svtage
4.5~5.5V 5V 4.5~5.5V, typical value of 5V.
Provozní proud
180 mA @ 5 V
5V 1A Recommended power supply: 5V 1A DC.
2.4 Operating Environment
Provozní teplota
Skladovací teplota
Provozní vlhkost
-10~60 (5V @ 60% RH)
-20~70 10%~90%RH 60%RH 10%~90%RH, typical value of 60% RH.
DMG48480F021_05WN_ Product Specification
Max
3225600
–
0.3
3.3
0.5
Unit bps
V
V
V
V
www.dwin.com.cn
4
400 018 9008
Profesionální, důvěryhodný, úspěšný
3 ESD ESD Test
DMG48480F021_05WN_ Product Specification
25°C50%RH Test temperature: 25°C. Test humidity: 50%RH.
15 cm
Test process: Place the product on the test bench fixture (approximately 15cm in height), and perform contact and air discharge tests on the smart LCM. Observe if any freezing, black or white screen, flickering, or rebooting occurs during the test.
ESD GB/T 17626.2 B Test conclusion: The product’s ESD performance meets GB/T 17626.2 Class B standards.
Typ výboje
Vypouštění vzduchu
Discharge Value
±8KV
Výsledek
Normální provoz
www.dwin.com.cn
5
400 018 9008
Profesionální, důvěryhodný, úspěšný
4 Ladění
DMG48480F021_05WN_ Product Specification
It is recommended for new users of DWIN smart LCMs to purchase official accessories. For more details, please
refer to customer service center. HDL662SZ5
Adapter board model: HDL662SZ5 FCC20_0.5 L=50mmB03692
Connecting cables: FCC20_0.5 L=50mm(B03692)
www.dwin.com.cn
6
400 018 9008
Profesionální, důvěryhodný, úspěšný
5 Packing Capacity & Dimension
Dimenze
Dimenze
Čistá hmotnost
56.18(W) ×59.71 (H) ×3.56(T) mm 15g
Packing Capacity
Model Carton
Size 415mm(L)×315mm(W)×165mm(H)
Vrstva
10
DMG48480F021_05WN_ Product Specification
/ Quantity/Layer
Množství (ks)
8
80
www.dwin.com.cn
7
400 018 9008
Profesionální, důvěryhodný, úspěšný
DMG48480F021_05WN_ Product Specification
www.dwin.com.cn
8
400 018 9008
Profesionální, důvěryhodný, úspěšný
6 Record of Revision
Rev
Datum revize
00
2025-08-14
Content First Edition
DMG48480F021_05WN_ Product Specification
Editor
Please contact us if you have any questions about the use of this document or our products, or if you would like to know the latest information about our products: Customer service Tel: 400 018 9008 QQ Customer service QQ: 400 018 9008
WeCom Customer service email: dwinhmi@dwin.com.cn DWIN Developer Forum: http://inforum.dwin.com.cn:20080/forum.php
Děkujeme všem za nepřetržitou podporu DWIN a váš souhlas je hnací silou našeho pokroku!
www.dwin.com.cn
9
400 018 9008
Profesionální, důvěryhodný, úspěšný
Důležité odmítnutí odpovědnosti
DMG48480F021_05WN_ Product Specification
DWIN reserves the right to make any changes to product designs without prior notice. Customers should ensure strictly adhering to all the relevant standards and requirements during the product application process, including but not limited to functional safety, information security, and regulatory provisions. DWIN shall not bear any joint and several liability for any consequences that may arise from customers’ adoption of DWIN products. In particular, for risks that may lead to significant property losses, environmental hazards, personal injury, or even death, especially in high-risk application areas such as military applications, flammable and explosive places, and life-saving medical equipment, customers should independently assess the risks and take corresponding preventive and protective measures. DWIN shall not bear any relevant responsibility.
www.dwin.com.cn
10
400 018 9008
Dokumenty / zdroje
 |
DWIN T5F0 Low Cost TFT LCD Display [pdfUživatelská příručka DMG48480F021_05WN, DMT80600C080_01W, T5F0 Low Cost TFT LCD Display, T5F0, Low Cost TFT LCD Display, TFT LCD Display, LCD Display |