Zavedení
This manual provides essential information for the proper installation, operation, and maintenance of the Wheelock WPBB-R Weather Resistant Back-Box. The WPBB-R is designed for outdoor use and is weatherproof, specifically intended for mounting ASWP Horn Strobes. It includes a weep hole and plug for drainage.
Před instalací si prosím pečlivě přečtěte tento návod a uschovejte si jej pro budoucí použití.
Bezpečnostní informace
VAROVÁNÍ: Installation must be performed by qualified personnel in accordance with all local and national electrical codes and regulations. Failure to do so may result in property damage, serious injury, or death.
- Před instalací nebo servisem zařízení vždy odpojte napájení.
- Ujistěte se, že všechny spoje jsou bezpečné a řádně izolované.
- Do not modify the product in any way. Use only genuine Wheelock accessories and parts.
- This back-box is designed for outdoor, weatherproof use. Ensure proper sealing during installation to maintain its weather resistance.
Konec produktuview
The Wheelock WPBB-R is a durable, red-colored metal back-box specifically designed to house Wheelock ASWP Horn Strobes in outdoor environments. Its robust construction and weatherproof features ensure reliable performance in various weather conditions.
Figure 1: Wheelock WPBB-R Weather Resistant Back-Box. This image shows the red metal back-box from an angled top-down perspective, revealing its square shape, internal mounting points, and the grey gasket around the opening.
Klíčové vlastnosti:
- Designed for use with Mounting ASWP Horn Strobes.
- Suitable for Outdoor USE/Weatherproof applications.
- Includes a WEEP Hole and Plug for moisture drainage.
- Constructed from durable metal with a powder-coated finish.
Nastavení a instalace
The WPBB-R back-box is designed for screw-in installation. Follow these general steps for proper setup:
- Výběr webu: Choose a suitable outdoor location that provides adequate support for the back-box and the ASWP Horn Strobe. Ensure the surface is flat and stable.
- Příprava na montáž: Mark the drilling points on the mounting surface using the back-box as a template. Ensure the weep hole, if used, is oriented downwards for proper drainage.
- Vrtání: Drill appropriate pilot holes for the mounting screws.
- Secure Back-Box: Attach the WPBB-R back-box to the mounting surface using suitable screws (not included). Ensure it is securely fastened and level.
- Zapojení: Route the necessary wiring into the back-box through the designated entry points. Ensure all wiring complies with local electrical codes.
- Install ASWP Horn Strobe: Mount the ASWP Horn Strobe onto the WPBB-R back-box, ensuring a tight and weatherproof seal. The back-box includes a gasket to aid in weather resistance.
- Weep Hole Management: The back-box includes a weep hole and a plug. For outdoor installations where moisture drainage is desired, ensure the weep hole is clear and positioned at the lowest point. If not needed or if a sealed enclosure is required, insert the provided plug.
- Závěrečná kontrola: Verify all connections are secure and the installation is robust.
Provozní
The Wheelock WPBB-R is a passive component designed to provide a weatherproof enclosure for ASWP Horn Strobes. It does not have active operational controls. Its function is to protect the mounted device from environmental elements.
Once properly installed, the back-box continuously performs its protective function. The operation of the ASWP Horn Strobe itself is independent of the back-box, beyond providing a secure and protected mounting point.
Údržba
The Wheelock WPBB-R back-box requires minimal maintenance. Regular inspections are recommended to ensure its continued integrity and performance, especially in harsh outdoor environments.
- Vizuální kontrola: Periodically inspect the back-box for any signs of physical damage, corrosion, or wear. Check the integrity of the powder-coated finish.
- Integrita těsnění: Ensure the gasket and seal between the back-box and the mounted ASWP Horn Strobe remain intact and free from cracks or degradation. A compromised seal can lead to water ingress.
- Plačící díra: If the weep hole is utilized, ensure it remains clear of debris (e.g., dirt, leaves, insect nests) to allow for proper drainage.
- Čištění: Clean the exterior of the back-box with a soft, damp cloth as needed to remove dirt or grime. Avoid abrasive cleaners or solvents that could damage the finish.
- Zabezpečení montáže: Verify that the back-box remains securely fastened to its mounting surface. Tighten any loose screws if necessary.
Odstraňování problémů
As a passive enclosure, the WPBB-R back-box itself typically does not experience "malfunctions." Most issues would relate to its protective function or physical integrity.
| Problém | Možná příčina | Řešení |
|---|---|---|
| Water/Moisture inside the back-box | Compromised seal/gasket; improperly installed weep plug; weep hole blocked. | Inspect and replace damaged gasket. Ensure weep plug is properly seated or removed if drainage is desired. Clear any obstructions from the weep hole. Re-seal the ASWP Horn Strobe to the back-box. |
| Back-box is loose on mounting surface | Loose mounting screws; inadequate mounting surface. | Tighten all mounting screws. If the surface is inadequate, consider reinforcing it or relocating the installation. |
| Visible corrosion or damage to back-box | Environmental exposure; physical impact. | Assess the extent of damage. Minor surface corrosion on the powder coat may be cleaned and touched up. Significant damage may require replacement of the back-box to ensure continued protection. |
Specifikace
| Atribut | Detail |
|---|---|
| Číslo modelu | WPBB-R |
| Značka | Wheelock |
| Materiál | Kov |
| Barva | Červený |
| Typ dokončení | Práškové lakování |
| Typ instalace | Šroubovací |
| Rozměry produktu | 2 x 5 x 5 palce |
| Hmotnost položky | 8 unce |
| Výrobce | EATON CORPORATION |
| UPC | 786697090141 |
| Kompatibilita | Designed for Wheelock ASWP Horn Strobes |
| Environmentální hodnocení | Outdoor USE/Weatherproof |
Záruka a podpora
For warranty information and technical support regarding your Wheelock WPBB-R Weather Resistant Back-Box, please refer to the official Wheelock or Eaton Corporation webwebu nebo se přímo obraťte na jejich zákaznický servis.
Výrobce: EATON CORPORATION (Wheelock is a brand of Eaton)
Please have your model number (WPBB-R) and UPC (786697090141) available when contacting support.
You can often find support contact details and product documentation on the manufacturer's official webmísto:
