Crocpad Anchor Point Instructions

Crocpad Anchor Point

How to add or replace a new anchor point

• Use a drill with a 48mm hole saw
• Drill a hole in a piece of timber and use it as a pilot hole
• Place the piece of timber with pilot hole on the mat where you need to make the hole – at least 400mm away from the edge
• Use the hole saw to drill carefully until you go completely through to the other side.
• Now you have the hole ready, insert the spacer into the anchor point as shown in Picture 2
• Insert the anchor point with the spacer into the hole.
• Now turn the mat and insert the second part of the anchor point into the hole as shown in picture 3
• Insert the screws and lock as shown in picture 4

• www.crocpad.com

Specifications

• Product: Anchor Point Kit
• Manufacturer: CrocPad
• Website: www.crocpad.com
• Required Tool: Drill with a 48mm hole saw
• Material: Spacer, Screws

Frequently Asked Questions (FAQ)

Q: Can I use a different size of hole saw for this product?
A: It is recommended to use a 48mm hole saw as specified for optimal performance and fit.

Q: What should I do if the anchor point does not fit securely after installation?
A: Double-check that you have followed the instructions correctly. If the fit is still not secure, contact customer support for assistance.