CREATE Ceramic Air Styler User Guide

CREATE Ceramic Air Styler User Guide

Thank you for choosing our product. Before using this appliance and to ensure its best use, please read the instructions carefully.
The safety precautions listed here reduce the risk of fire, electric shock and injury when properly followed. Keep the manual in a safe place for future reference, as well as the warranty, sales receipt and carton. If applicable, give these instructions to the future owner of the appliance. Always follow basic safety instructions and hazard prevention measures when using an electrical appliance. The manufacturer shall not be liable for any damage resulting from the user’s failure to follow these instructions.

SAFETY INSTRUCTIONS

Always read the basic safety precautions carefully before using any electrical appliance.

• Please keep the power cord in good condition, the cord should never be cut, damaged, excessively bent, pulled, twisted, knotted, or placed near high temperatures, this could cause a short circuit, fire and electric shock.
• Do not use the power cord if the plug is damaged or if the socket is loose, otherwise, there may be danger of fire due to short circuit and electric shock, etc.
• Do not allow persons (including children) with phy- sical, sensory or mental impairments or lack of re- levant experience and knowledge to come into con- tact with this product or use it alone to avoid burns, electric shock and other accidents.
• Do not use the product for purposes other than tho- se intended to prevent accidents.
• Do not store the product in the bathroom or use near water.
• Check the product for damage before use and dis- continue use if damaged.
• When the cleaning icon appears, press the reverse cleaning mode to remove dust.
• Do not use this product in an environment with ex- cessive dust, this could affect the life of the engine.
• Do not place this product directly under an air con- ditioner to prevent condensation from dripping onto the product and causing damage.
• Do not strike this product with hard objects to pre- vent damage or malfunction.
• Do not use this product near gas appliances, hea- ting devices or cookers, otherwise it may damage the product or cause a fire.
• After use and before cleaning the product, be sure to unplug the power plug to prevent damage to the product.
• Do not dismantle or repair the product without authorization. To avoid damage, if the product needs to be repaired, contact customer service.
• This product should only be repaired by qualified personnel.

WARNING! Do not use this appliance near bath- tubs, showers, washbasins or other vessels con- tainting water.

LIST OF PARTS

1. Heating plate
2. Display
3. Cool air button
4. Temperature button
5. Speed button
6. Power button
7. Air inlet
8. Air outlet
9. Lock button
10. Removable air inlet grille

CONTROL PANEL

HOW TO USE

ON

• Plug the appliance into the mains socket, the display will show the word “0FF”.
• Briefly press the power button to switch on the appliance.
• Press and hold the power button to turn off the appliance.

TEMPERATURE

• You can set the desired temperature using the “temperature knob”.
• There are 5 temperature levels 90- 120-140-160ºC.
• Press the button each time to switch between the different temperatures, this button can also be used to access the cold air function.

COLD AIR

• To access the cold air function directly, press the “cold air button” and you will get cold air quickly with a single press.
  The display will show “COL”.

SPEEDS

• Briefly press the “speed button” to set the desired speed.
• 3 speed levels are available.

CLEANING MODE

1. After 24 hours of full use, the cleaning indicator will light up. , indicating that the appliance needs to be cleaned.
2. With the display “OFF” press and hold the speed button for 5 seconds to enter the cleaning mode.
3. The display will show the cleaning icon ““ and will stop automatically after 20 seconds. The display will show “OFF” after it stops.

DRYER MODE

• This hair straightener has a blow straightening function, after switching it on, it fuses the two sides of the heating plate together and enters blow straightening mode.
• You can freely choose the appropriate air speed and temperature, if you need to set the hair straightener to blow-drying.
• Please slide down the lock button to use it.

1. When using the straightener for the first time, select the temperature setting that best suits your hair type.
   Suggestions:
   • For thick and hard hair, the recommended temperature selection is 140-160°C.
   • For normal hair a temperature of 90-120°C is recommended.
   • For fine hair, cold air is recommended.
2. Comb the hair before using the appliance so that there are no knots.
3. Take a strand of hair no wider than 60 mm and place it evenly on the styling panel.
4. Hold for about 5 seconds to achieve straightening of the hair. Repeat several times until the desired hairstyle is achieved.
5. When styling your hair, you can choose the blowing mode to release a large amount of cold air, so that the hair is better shaped and the styling effect is faster and longer lasting.

CLEANING AND MAINTENANCE

• Never immerse this product in water or any other liquid.
• Do not use corrosive or flammable cleaners, such as bleach or alcohol, to clean any part of this product.
• Do not use with styling mousse, styling spray, hairspray, hairspray, …
• Before cleaning the appliance, unplug it and turn off the power supply.
• Use a clean, damp cloth to wipe dust from the body of the appliance.
• Store in a dry place until next use.

PROBLEMS AND SOLUTIONS

This marking indicates that this product must not be disposed of with other household waste throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where you purchased the product. They can take this product for environmentally safe recycling.