INTRODUCTION

Congratulations on your new purchase!

Before using this guide there are a few things you need to know:-

• Call Blocker protects a single phone, or a cordless phone with multiple handsets
• CPR Call Blocker requires your line to have Caller Identity service (Caller ID) from your telephone operator.
• Caller ID is a service that forwards the caller’s number to you with each call. It is available from most telephone companies. You might be familiar with this from your mobile phone. To register for Caller ID contact your telephone operator by dialling 150 – it is available free with BT and most other providers
• The CPR Call Blocker will work with a wide range of telephone equipment including corded and cordless phones. It protects all the phones that are plugged into it. If you need a number of extensions in your house we recommend that you use a modern multi-handset cordless phone system so that the CPR Call Blocker can protect all your phones.
• We recommend that you don’t use the CPR Call Blocker with phones plugged into other extension sockets in your house. These may give a short ring when calls from unknown callers are received, and won’t ring when the caller is put through.
• Some phones automatically check the 1571 network voicemail service at regular intervals and display a ‘Message waiting’ light. These are called 1571 phones. We recommend that you do not use 1571 phones with The CPR Call Blocker.
• We recommend that you don’t plug The CPR Call Blocker into a wireless phone line extension box, as these don’t forward Caller ID.

SETTING UP CPR CALL BLOCKER

Step 1

Remove the line cable from your telephone and plug into the LINE 1 port of the Call Blocker.

Step 2

Use the small Black cable provided to connect the TEL 1 port to your telephone

Step 3

Insure all cables are connected securely

The Call Blocker is setup correctly when there is a red light displayed on the top of the unit, this is shown when the phone is off the receiver or when on a call. If you are using a cordless phone then press the Call Button for a dial tone.
If you have no dial tone or no red light you will need to disconnect the cables then reconnect using the LINE 2 and TEL 2 ports.

INSTALLATION DIAGRAM

BLOCK NOW

The easiest way to block Nuisance Callers is to use the BLOCK NOW button located on the top of the Call Blocker.

When a Nuisance Caller gets through press the ‘BLOCK NOW’ button and then hang up the call, this Caller will now be blocked from calling again.

You can also use this function without having to answer the phone.

For example: If an unfamiliar number is calling , press the BLOCK NOW button and the CPR Call Blocker will stop that number from calling again.
The Block Now Button only works with Visible numbers.
If you are receiving nuisance calls from ‘WITHHELD’ or ‘INTERNATIONAL’ numbers please use the pr ogramming codes on pages 5 and 6.

PROGRAMMING CODES

Programming a number into “Blocking” list

1. Pick up the telephone and input * *7 # you will hear a “Beep”
2. Then enter the telephone number you wish to block, followed by the # key, You will hear a ‘beep’ after each # to confirm success.
3. Enter the next number or hang up t o complete setup.

Programming an area code into “Blocking” list

1. Pick up the telephone and input * * 7 # you will hear a “Beep”
2. Then enter the area code you wish to block, followed by the # key, You will hear a ‘beep’ after each # to confirm success.
3. Enter the next area code or hang up t o complete setup.

Erasing one number or ar ea code from the “Blocking” list

1. Pick up the telephone and input * * 6 # you will hear a ‘Beep’
2. Then enter the telephone number you wish to delete followed by the # key, You will hear a ‘beep’ after each # to confirm success.
3. Hang up to complete setup.

Block Last Calling Number

1. To block last number : Get a dial tone and input * * 2 # * 2 # You will hear a ‘beep’ after each # to confirm success.

Turning Call Blocker On and O ff

1. To Turn On: Get a dial tone and input * * 4 # *4#
2. To Turn Off : Get a dial tone and input * * 3 # *3# You will hear a ‘beep’ after each # to confirm success.

Blocking all “Withheld” Callers

1. To Turn On: Get a dial tone and input * * 7 # 7*#
2. To Turn Off : Get a dial tone and input * * 6 # 7*# You will hear a ‘beep’ after each # to confirm success.

Alternative “Withheld” blocking function ( Use this if the c onventional code doesn’t work)

1. To Turn On: Get a dial tone and input * * 7 # #
2. To Turn Off : Get a dial tone and input * * 6 # # You will hear a ‘beep’ after each # to confirm success.

Blocking all “International” Callers

1. To Turn On: Get a dial tone and input * * 7 # * #
2. To Turn Off : Get a dial tone and input * * 6 # * # You will hear a ‘beep’ after each # to confirm success.

Blocking all IP Dialling sy stems (skype / overseas nuisance call centres)

1. To Turn On: Get a dial tone and input * * 7 # 6*#
2. To Turn Off : Get a dial tone and input * * 6 # 6*# You will hear a ‘beep’ after each # to confirm success.

Blocking all “0” type calls (Single digit spoof callers)

1. To Turn On: Get a dial tone and input * * 7 # 0#
2. To Turn Off : Get a dial tone and input * * 6 # 0# You will hear a ‘beep’ after each # to confirm success.

Resetting the Call Blocker back to factory settings

1. Get a dial tone and input ** 1 # * 1 # You will hear a ‘beep’ after each # to confirm success.
   Note: Three “Beeps” indicated that an error has occurred – Either a number has been entered incorrectly or the func tion is already ON.

FREQUENTLY ASKED QUESTIONS

GENERALIN FORMATION

Safety

• Simply clean CPR C all Blocker with a damp cloth. D o not use chemicals or abr asive cleaning products.
• Do not open CPR C all Blocker as there are voltages inside the unit.

Environmental

• CPR Call Blocker is intended for indoor use only.
• Do not submerge any part of CPR Call Blocker in water and do not use it in damp or humid conditions, such as in ba throoms.
• Do not expose CPR Call Blocker to fire, explosive or other hazardous conditions.
• There is a slight chance that CPR Call Blocker could be damaged by an electrical storm.
  We recommend that you unplug the telephone line cord for the duration of the storm as such damage is not c overed by the guarantee.

Data Protection

We are registered under the Data Protection Act 1998 (registration Z2140320 ).
The data controller is CPR Global Limit ed of York Chambers, York Street, Swansea , SA1 3LZ
We will process personal data disclosed by you in accordance with our privacy policy published on our w eb site (www.cprcallblocker.com)

NEED MORE HELP?

Need more help?
If you need further help setting up CPR C all Blocker please email or phone thr ough to our Technical support team for help with problems, or advice.

CUSTOMER SERVICES

CPR Global Post : CPR Global LTD
York Chambers
York Street
Swansea
UK
SA1 3LZ
E-mail : support@cprcallblocker.com
Phone : +44 0800 652 7780
© CPR Global 2012
Patent Number – 1200049.3
www.cprcallblocker.com


Disposal instructions Waste electronic equipment should be separated from your normal household waste and taken to your local recycling centre for disposal, or back to where you bought the equipment.
Proper recycling of electronic equipment will help
For more products from CPR Global, please visit our website www.cprdistribution.com
And view our fantastic range of innovative products