cossiga GOGRF9 GOG Tower Counter User Guide

GOG TOWER TOWER COUNTER SERIES

Contents hide

1 GOGRF9 GOG Tower Counter

2 CABINET DIMENSIONS & SPECIFICATIONS

3 Documents / Resources

3.1 References

4 Related Posts

GOGRF9 GOG Tower Counter

RF GOGRF9
GOGRF12
GOGRF15

Double glazed, condensation free, glass on glass construction
Sliding double glazed rear doors argon filled

Deck forced refrigeration
Double glazed with painted edges

Adjustable glass shelf (additional shelf available)
Ticket strips on shelf and deck

Under shelf and canopy LED lights
Integral condenser, self evaporating

HT GOGHT9

Deck forced heating
Single glazed glass with front tilting hinged glass

Sliding glazed rear doors
Deck forced heating

Two adjustable shelves
Ticket strips on shelf and deck

Under shelf and canopy LED lights

CABINET DIMENSIONS & SPECIFICATIONS

Maximum shelf load weight 15kg spread evenly


CORRECT AIRFLOW	IN CORRECT AIRFLOW

Blocked air flow will retard operation on both HOT and COLD units
Ensure trays or plates are not blocking air flow at rear

Locations to avoid

Close to shop front exterior

In an outside location
In direct sunlight

In a high wind
Near any source producing excessive heat

Service units more frequently in dusty or polluted areas

Environmental conditions
Heat from other equipment and natural conditions, such as direct sunlight straight on units, can cause cooling to fail and overload compressor

EXTRACTION FAN

Extract hot air from box joinery
Fan and power cable supplied, screw fixed to joinery
Electrical power cord 2000mm 3 pin 10 amp 1 phase socket required
Fan 230v ~ 50Hz – 60Hz – 19 Watt in stainless steel case
Cossiga part number X000611 Extraction Fan

VENTILATION GRILL

Stainless steel construction
Hole cut out size 540 mm x 298 mm
Cossiga part number X000765 Ventilation Grill Screws not included

THESE UNITS ARE HEAVY AND REQUIRE LIFTING INTO BENCH TOPS

◁ REMOVE
To reduce weight remove
– All doors
– Shelving
– Base plates

▷ PLAN AHEAD
– Have plenty of labour on hand
– Use a mechanical lifting device – optional
– Check bench top hole measurement
– Ensure enough clear depth in cabinet work
– Protect bench top with a mat or similar
– Pre-adjust unit feet if needed

All accepted local safety work wear and standards should be adhered to with a safety programme developed before undertaking of this kind of lifting work