CORSTON Fixed Spindle Installation Guide

CORSTAN-logo

CORSTON Fixed Spindle

CORSTON-Fixed-Spindle

Contents

CORSTON-Fixed-Spindle-fig-1

Tools you’ll need

CORSTON-Fixed-Spindle-fig-2

Fixed Spindle Installation Instructions

  1. Mark the centre lines and hole spacings on both sides the door. Make sure they are vertically flipped on each side.CORSTON-Fixed-Spindle-fig-3
  2. Drill holes through the door for the through bolts with the 8mm drill bit.CORSTON-Fixed-Spindle-fig-4
  3. Drill pilot holes for the wood screws with the 2mm bitCORSTON-Fixed-Spindle-fig-5
  4. Clip snap off screws to size so that they are smaller than the depth of the doorCORSTON-Fixed-Spindle-fig-6
  5. Screw the fixed spindles to the door with the through boltsCORSTON-Fixed-Spindle-fig-7
  6. Drive the wood screws in to the doorCORSTON-Fixed-Spindle-fig-8
  7. Screw the roses and the handles on to the Fixed SpindleCORSTON-Fixed-Spindle-fig-9
  8. If after screwing the handle on there is a gap bigger than a 1mm between the handle and rose, use the washer to fill the gap.CORSTON-Fixed-Spindle-fig-10
  9. Replace the grub screw in the handle with the grub screws with pre-applied threadlockCORSTON-Fixed-Spindle-fig-11
  10. Screw the grubscrew in to the handle and make it it is levelCORSTON-Fixed-Spindle-fig-12
  11. Wait 45mins for the threadlock to fully set.CORSTON-Fixed-Spindle-fig-13

corston.ae/support
hello@corston.ae

Documents / Resources

PDF thumbnailFixed Spindle
Installation Guide · AE_Fixed_Spindle_Instructions.pdf v 1727089470, Fixed Spindle, Spindle

References

Ask a Question

Use this section to ask about setup, compatibility, troubleshooting, or anything missing from this manual.

Ask a Question

Ask about setup, compatibility, troubleshooting, or anything missing from this manual. Name and email are optional.