CONTROL by WEB WEB 9-28VDC Relay Controller Power Supply 

Basic Setup Steps

1. Power the module and connect to network.
2. Set IP address on computer to be on the same network as the module. (Example: Set computer to 192.168.1.50)
3. To configure the module, open a web browser and enter:
   http://192.168.1.2/setup.html
4. Assign permanent IP address to module, then restart module.
5. Restore computer’s IP address, if necessary, and access the module at its new IP address to finish setup.

Factory Default Settings

IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Control Page Web Address: http://192.168.1.2
Control Password: (no password set)
Setup Page Web Address: http://192.168.1.2/setup.html
Setup Username: admin
Setup Password: webrelay (all lower case)

Pinout Diagram

	Vin+	DC Power Supply Input (see below*)
	Vin-	DC Power Supply Input (Ground)
	1C	Relay 1 Common
	1NC	Relay 1 Normally Closed
	1NO	Relay 1 Normally Open
	2C	Relay 2 Common
	2NC	Relay 2 Normally Closed
	2NO	Relay 2 Normally Open
	3C	Relay 3 Common
	3NC	Relay 3 Normally Closed
	3NO	Relay 3 Normally Open
	4C	Relay 4 Common
	4NC	Relay 4 Normally Closed
	4NO	Relay 4 Normally Open

*Vin+ Voltage:
I Model: 9-28VDC
E Model: POE or 9-28VDC

Customer Support

www.ControlByweb.com
1681 West 2960 South, Nibley, UT 84321, USA

Documents / Resources

CONTROL by WEB WEB 9-28VDC Relay Controller Power Supply [pdf] User Guide WEB 9-28VDC Relay Controller Power Supply, WEB 9-28VDC, Relay Controller Power Supply, Controller Power Supply, Power Supply

References

• User Manual