Conrad 20231012 Solar Powered Wireless Security Camera User Guide

United States: +1-866-905-9950 Mon-Fri 9AM-5PM (PST)
United Kingdom: +44-20-3885-0830 Mon-Fri 9AM-5PM (GMT)
Germany: +49-32-221094692 Mon-Fri 9AM-5PM (CET)
Japan: +81-50-5840-2601 Mon-Fri 9AM-5PM ( JST )

support@aosulife.com www.aosulife.com @aosulife

AOSU Care

Hi Customer
Thank you for choosing AOSU security products. We have always put our customers first and foremost.
There are 3 things you should know before using this product

1. Micro SD Card
If you don’t have a Micro SD Card available at home now and don’t want to spend extra time choosing one, please contact us directly. TIP: the Micro SD Card gotta be formatted after inserting it up.

2. Select 2.4G Wi-Fi
The product only supports 2.4G Wi-Fi, please select 2.4G Wi-Fi when setting up the app.

3. Select installation location.
Please use your mobile phone to test the coverage of the home Wi-Fi signal at the planned installation position before installation, so that the product can receive a better signal.
Get all the tutorial videos of using product including but no limit to set up the app, installation and format micro sd card, visit: aosulife.com
Join “AOSUCare” today as three ways below to get all of your problems solved by one-on-one live chat and phone service tech support.

support@aosulife.com www.aosulife.com @aosulife

What’s Included

SolarCam D1 Lite

Camera (1) Screw Pack USB-C Charging Cable

Position Sticker Security Sticker Quick Start Guide

Solar Panel

Solar Panel Universal Joint Socket nut

Locking Screw Cap Mounting base (2) Mounting Screws and Anchors

Product overview

Antenna
PIR Motion Sensor

Lens
Microphone

Infrared LEDs/Spotlights
Status LED

Reset button

Micro SD Card Slot
Power

Speaker

CAUTION: Please insert the Micro SD Card according to the direction shown in the diagram. Micro SD Card might JAM if inserted incorrectly and device could be damaged.
SD Card Port: Support Micro SD Card for local storage (Max 512GB).
Reset button: Press and hold the button for 3 seconds, and then the device will be ready to be connected.
Card capacity requirements: 8-512GB.
Read and write speed requirements: class10 level.
File format: FAT32.

Setting Up the System

Download the Aosu App from the App Store (iOS devices) or Google Play (Android devices).

Mounting the Camera

Find a Good Mounting Spot

To find a spot to mount Camera, you need to test wireless signal strength.
① Open the aosu App, go to Camera Settings > Mounting Guide.
② To test the wireless signal strength, take your camera and phone to the location where you want to mount the camera.
③ Move the camera as close to the Wi-Fi Router as possible to get a better signal.

Select Height and location

Hang Camera 2-3 Meters above the ground. This height maximizes the detection range of the motion sensor of Camera. Avoid placing Camera under direct sunlight.

Test the Wi-Fi signal at installation position

Use cell phone to test Wi-Fi signal quality at the installation position before installing camera, make sure the Wi-Fi router can provide good Wi-Fi signal.

Installation

Drilling according to position sticker, drill bit: 15/64”(6 mm).
Insert the plugs.
Tighten the screws.

What is required:

Power Drill (not provided) 15/64″(6mm) Drill Bit

Sticker
Wall
Base bracket
Screws

Camera
Wall Anchors

Installation instruction of solar panel

1. keep the installation angle of solar panels about 30-45° with the horizontal plane, as shown in the picture below.
2. The installation between the solar panel and the camera is shown in the following figure (open up the silicone cover at the bottom of the camera, remove the small center part of the cover, insert the power cord through the opening and plug it into the USB-C Port and then close the cover taking up any slack in the power cord from the solar panel).

3. Take care to install the solar panel so that the sun is not blocked by any items such as eaves, trees branches, etc.
4. Tighten the camera to the mounting bracket.

Place Solar Panel in an area with consistent sunlight throughout the year. It only needs a few hours of direct sunlight each day to keep your camera powered.
The amount of energy that the solar panel produces is affected by weather conditions, seasonal changes, geographic location etc.

1. Fix the base to your mounting location using the included screws. If the installation surface is soft or unstable, first use a φ6.0 drill bit to drill a hole in the wall, then insert the anchor nail into the hole, and fix the base with screws.

Wall Anchors
Base
(2) Mounting Screws

Wall

2. First, install the locking screw cap into the universal joint and then screw the circular socket nut into the universal joint.

Locking Screw Cap
Universal Joint
Front

Socket nut
Back

3. Screw the universal joint into the back of the solar panel. Tighten it firmly with the attached nut.

Solar Panel

4. Screw the locking screw cap into the base. Make sure that the universal joint is angled upward.

Base
Locking Screw Cap

5. When adjusting the solar panel left or right, loosen the locking screw cap, turn the sleeve rod, and tighten the locking screw cap when the panel is in position.

a) Locking Screw Cap

a) Sleeve Rod
b) Locking Screw Cap

6. Solar panel’s angle can be adjusted up and down up to 90°.

Tip: After the installation is complete, please check that all locking mechanisms are tightly secured.

Notice

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee EN that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/ TV technician for help.

FCC Radio Frequency Exposure Statement

The device has been evaluated to meet general RF exposure requirements.
The device can be used in fixed/mobile exposure condition. The min separation distance is 20cm.

This product complies with the radio interference requirements of the European Community.

Declaration of Conformity

Hereby, Aosu declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
For the declaration of conformity, visit the Web site: https://www.aosulife.com.
This product can be used across EU member states.
Do not use the Device in the environment at too high or too low temperature, never expose the Device under strong sunshine or too wet environment.
The suitable temperature for Camera and accessories is -10°C – 50°C.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body.
For Camera : Wi-Fi Operating Frequency Range:
2412~2472MHz ; Wi-Fi Max Output Power: 17.13dBm(EIRP)

This product is designed and manufactured with high quality materials and components, which can be recycled and reused.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

Customer Service

Warranty

12-month limited warranty (The actual warranty period shall be implemented according to the requirements of local laws and regulations)

Email Us

Customer Support: support@aosulife.com

Call Us

Facebook: @aosulife
Twitter: @aosulife
YouTube: @aosulife

Documents / Resources

Conrad 20231012 Solar Powered Wireless Security Camera [pdf] User Guide
20231012 Solar Powered Wireless Security Camera, 20231012, Solar Powered Wireless Security Camera, Wireless Security Camera, Security Camera, Camera

References

User Manual

Solar-Powered Wireless Security Camera

SolarCam D1 Lite

Quick Start Guide