User Guide

CONCEPTRONIC Logo

CONCEPTRONIC Enclosure USB-C 3.1 Gen 2

CONCEPTRONIC Enclosure USB-C 3.1 Gen 2

M.2 PCIe NVMe SSD Enclosure USB-C 3.1 Gen 2
DDE01B

 

Assembly Guide

Step 1

FIG 1 Assembly Guide

Remove the two screws out, and then remove the PCB.

Step 2
FIG 2 Assembly GuideInstall the M.2 PCIe NVMe SSD into PCB and secure it with a screw.

Step 3

FIG 3 Assembly Guide

Slide the PCB back into the enclosure. Replace the front plate and fix it with the screws which were removed in step 1.

Assembly Finished!

 

Installation & usage

Connect to computer

  • Connect the USB Type-C cable to the enclosure and to a free USB port on your computer.
    The computer will automatically recognize and install the new hardware. No driver installation is required.

NOTE:
To enjoy USB 3.1 super speed up to 10Gbps, your computer must be equipped with built-in USB 3.1 ports, or a USB 3.0 host PCI-e card. (If the USB cable is connected to USB2.0, the transfer speed will down to 480Mbps.)

Disconnect to computer
The M.2 PCIe NVMe SSD Enclosure must be removed safely before you disconnect it from your computer, in order to prevent data loss.

  • Double click on the “Safely Remove Hardware” icon in your system tray.     FIG 4 Disconnect to computer  The “Safely Remove Hardware” window will be shown.
  • Click on the connected M.2 PCIe NVMe SSD Enclosure (often listed as “USB Mass Storage Device”) and click the “Stop” button.
  • Confirm the disconnection by clicking “OK”.

The M.2 PCIe NVMe SSD Enclosure is now safely removed from your computer.

 

File Downloads

User Guide
Enclosure USB-C 3.1 Gen 2, DDE01B
Download [optimized]
Download

Leave a comment

Your email address will not be published.