comsol WCFS10 Folding Wireless Fast Charging Stand User Manual

Two coils enable large wireless coverage to allow charging in portrait and landscape modes
Supports 7.5W Apple wireless fast charging for iPhone 8 or later

Supports 10W wireless fast charging for compatible devices such as Samsung Galaxy Series and more” Supports 5W standard wireless charging for all Qi enabled devices
No need to remove your protective case. Works with most cases up to 3mm thick

LED indicator to show charging status
Smart IC enables energy saving mode when device is fully charged

Full safety protection for your devices with Qi certified temperature control, strict voltage regulation & short circuit protection
Includes 1.5m USB-A to USB-C charging cable (does not inlcude USB wall charger)

Check with device manufacturer for Qi wireless compatibility
When connected to a QC 2.0 or QC 3.0 wall charger (not inlcuded)

Wireless Charger Operation

Connect the wireless charging stand to a USB wall charger (not included)
The red LED will be on for 3 seconds to indicate the charging pad is powered on and in stand-by mode

Place your wireless phone on the charging stand and your phone should start charging automatically
The LED will fiash green to indicate charging

if your phone does not not start charging, move your phone until the correct position is found and your phone starts charging
When your phone is fuly charged, the Smart IC enables energy saving trickle charge mode

Please Note: When wirelessly charging a device, the wireless charger and your device may feel warm. This is a normal operating condition and should not be cause for concern.

Specifications

Wireless Standard: WPC/Qi (v1.2.4)
Quantity of Wireless Charging Coils: Two Coils
Input: DC 5V 2A or 9V 1.67A
Output: 5W/ 7.5W / 10W
Working Frequency: 110 to 205KHz
Charging Distance: 3 to 8mm
Charging Efficiency: >72%
Dimensions: 126 x 66 x 16.5mm

Important Safety Instructions

Only use original or reputable third party chargers and cables
Do not get wet to avoid causing short circuit damage and leakage
Do not use in extreme hot, humid or corrosive environments to avoid short circuit damage and leakage
Do not place too close to magnetic strip or chip ID card to avoid magnetic failure
Do not place within 20cm of implantable medical devices (pacemaker, cochlear implant etc.) to avoid potential interference
Do not clean with harmful chemicals or detergents
Misuse, dropping or excessive force may cause damage to the charging stand.

iPhone is a trademark of Apple inc., registered in the U.S. and other countries. The ‘Qi’ Symbol is a trademark of the Wireless Power Consortium. Android is a trademark of Google Inc.