Command 17003ES Large Utility Hook
USING INSTRUCTION
APPLY
- Clean surface with rubbing alcohol. Do not use household cleaners.
- Remove red liner. Press adhesive to hook.
- Remove black liner. Press to wall for 10 seconds.
- To ensure adhesive hold, slide the hook up and off.
- Press the base firmly for 30 seconds.
- Slide the hook back on. Wait 1 hour before use.
REMOVING INSTRUCTION
REMOVE
- Slide hook up and off.
- Gently hold mounting base in place.
- Never pull the strip towards you! Always pull straight down.
- Stretch the strip slowly against the wall at least 15 inches to release.
Hook can be reused with Command® Large Refill Strips.
CAUTION: Do not hang over beds or on wallpaper. Do not hang valuable or irreplaceable items or framed pictures. Use indoors 50°-105
WARRANTY
Limited Warranty and Limitation
of Liability for product sold in USA: This product will be free from manufacturing defects. If defective, your exclusive remedy shall be, at 3 M’s option, product replacement or refund. 3M will not be liable for any loss or damage arising from this product, whether direct, indirect, special, incidental, or consequential.
CONTACT INFORMATION
- Failure to follow instructions carefully may cause damage.
- Save instructions or visit command.com
Documents / Resources
 |
Command 17003ES Large Utility Hook [pdf] Instruction Manual 17003ES Large Utility Hook, 17003ES, Large Utility Hook, Utility Hook, Hook |