ROVER2 NASA Perseverance Rover Controller
Instruction Manual
ROVER2 NASA Perseverance Rover Controller
NASA Perseverance rover
Read before flight
NASA Perseverance rover controller
How to connect the NASA Perseverance rover with controller
- Turn on the controller
- Turn on the NASA Perseverance rover
- Press and hold the PAIR button on both the controller and the NASA Perseverance rover to pair them.
After the connection is successful, you can start using the controller tocontrol the NASA Perseverance rover.
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NASA Perseverance rover controller：
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
NASA Perseverance rover：
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Documents / Resources
 |
CircuitMess ROVER2 NASA Perseverance Rover Controller [pdf] Instruction Manual 2AVZ4-ROVER2, 2AVZ4ROVER2, ROVER2 NASA Perseverance Rover Controller, ROVER2, NASA Perseverance Rover Controller, Perseverance Rover Controller, Rover Controller, Controller |