ChunHee WT26 Wireless Intercom

Wireless Intercom Manual

Features

• 16 Channels
• Emergency Alarm
• VOX Hands Free
• Adjustable Volume
• 1640ft Working Range
• Type-C Charge Port
• Rechargeable Battery
• Low Battery Alert
• Clear & Loud Voice
• TOT (Time out timer)

Instruduction

• Please read this manual thoroughly. It will help us to know how to use this intercom system and make the operation easier.
• The intercom contains non-repairable parts. Opening them may damage sensitive components and will void the warranty.

Specification

Overview

Operation

1. Trun ON/OFF
   Hold the [ ] button for 3 seconds to turn on or turn off the intercom.
2. Channel Change
   • Press the [CH+] button to increase the channel (16 channels Available);
   • Press the [CH-] button to decrease the channel (16 channels Available).
3. Volume Change
   • Press the left [Volume+] button to increase the volume level (8 Volume Levels Available);
   • Press the left [Volume-] button to decrease the volume level (8 Volume Levels Available).
4. Keyboard Lock/Unlock
   Hold the [CH+] button for 3 seconds to lock or unlock the keyboard.
5. VOX-Turn ON
   • Press the [ ] button to turn on the intercom, then hold the [Volume-] button for 3 seconds till you hear a ‘VOX ON’ voice prompt to release.
6. VOX-Turn OFF
   • Press the [ ] button to turn off the intercom, the VOX set will be off.
7. Emergency Alarm
   • Hold the left [Volume+] button for 3 seconds to alarm, press the PTT button to stop the alarm.
8. Clip Install
   Insert the intercom into the clip, then press the top of the clip into the groove on the top of the intercom, and you will hear a click indicating that the back clip has been installed successfully.
9. Language (Chinese/English) Voice Prompt Change
   Turn on the intercom, then change the channel to 15, and then turn off the intercom, finally, hold the [CH-] and [ ] buttons at the same time for 3 seconds to turn on the intercom to switch between Chinese and English voices.
10. Start Talk
    • Method 1: Hold the left side PTT button to speak.
    • Method 2: Hold the front round PTT button to speak.
    • TIPS: Please keep listening (do not press the PTT button) while the other person is speaking, otherwise, the intercom will stop receiving the signal.
11. TOT (Time out timer)
    The intercom will stop transmitting when the speaking time reaches 60 seconds.

• CTCSS and DCS tones are similar to access codes and enable the radio to communicate only with the users that are tuned on the same channel and have set the same code. For each channel, you can set up to 50 CTCSS tones and 155 DCS codes. The CTCSS/DCS tones are a sort of “access codes” and enable the radio to communicate only with the other users set on the same frequency and on the same  CTCSS/DCS tone. Undesired signals coming from other stations set on the same frequency but with different CTCSS/DCS tones won’t be received.

1. Blue Color: Charging
2. Green Color:
   • Fully Charged
   • Receiving Signal (Listening)
   • Standby (Flashes every 10 seconds)
3. Red Color: Transmitter Signal (Speaking)

• The microphone will beep while the device is within 1 meter. Please don’t worry about it, just need to separate them from each other.
• We suggest to place the product into the charge station to charge, it will protect the intercom.
• The intercom system does have not a waterproof design, please take the product away from water.
• The intercom system is powered by battery, please Do not place the the product in a flammable or explosive environment.

Troubleshooting

1. Remove and reattach the battery.
2. Recharge the battery.
3. Clean the battery contacts.

Q2: The voice is weak or intermittent during receiving.
A2:

1. Recharge the battery.
   
2. Clean the surface of the speaker.

Q3: Can’t communicate with other group members
A3:

1. Check the channel is on the same channel.
2. Increase the volume level.

Q4: Hear unknown voices or noise.
A4: Change the channel.

Q5: Unable to hear anyone because of too much noise and hiss.
A5:

1. Move towards other members (make the distance of the intercoms within 150ft).
2. Move to an open and flat area, restart the intercom, and try again.
3. Stay away from equipment that will cause interference.

Q6: The radio keeps transmitting.
A6:

1. Turn off the VOX function.1) Move towards other members (make the distance of the intercoms within 150ft).
2. Turn off the intercom, then turn on again.

• Contact our friendly support team for quick solutions. Friendly reminder: When contacting us for help, be sure to have your product handy for troubleshooting!
• Email: chunheeus@126.com

More Products on ChunHee Amazon Store

FCC Warning Statement

1. This device may not cause harmful interference, and
2. this device must accept any interference, including received interference, that may cause undesired operation.

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the eceiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. Do not use this device when the antenna shows obvious damages. Hold this transmitter approximately ?? mm away from your face and speak normally with the antenna pointed up and away. Use the supplied belt clip for body-worn configuration as other accessories may not comply to the limits.

Documents / Resources

ChunHee WT26 Wireless Intercom [pdf] Owner's Manual WT26, WT26 Wireless Intercom, WT26, Wireless Intercom, Intercom

References

• User Manual