Home » Chummaven » Chummaven YB-1117 Modern Swivel Bar Stools Set of 2 Instruction Manual 

Chummaven YB-1117 Modern Swivel Bar Stools Set of 2

Specifications
Component |
Quantity |
Screw Size |
A (Chair Back) |
x 1 |
|
B (Chair Legs) |
x 2 |
|
C (Support Bars) |
x 4 |
|
D (Seat Base) |
x 1 |
|
E (Swivel Base) |
x 1 |
|
F (Screws) |
x 5 |
M6x12mm |
G (Screws) |
x 4 |
M6x16mm |
H (Screws) |
x 8 |
M6x20mm |
I (Screws) |
x 4 |
M6x30mm |
J (Allen Key) |
x 1 |
|
Product And using Instruction
- Assembly Steps
- Align the chair legs (B) with the support bars (C) and secure using screws (F). Use the Allen Key (J) to tighten the screws.
- Attach the remaining support bars (C) to the assembled legs using screws (H). Ensure to cross the bars as shown in the diagram.
- Place the seat base (D) onto the assembled leg structure, aligning the screw holes.
- Secure the swivel base (E) to the seat base (D) using screws (F). Tighten the screws with the Allen Key (J).
- Attach the chair back (A) to the seat base by aligning it with the swivel base and using screws (G) to secure it in place.
- The chair is now fully assembled. Review all screws to ensure they are tight and the chair is stable before use.
FAQs
- What tools are needed for assembly?
- An Allen Key (J) is included and is the only tool required for assembly.
- Can I use a power tool to assemble the chair?
- It is recommended to use the provided Allen Key to avoid over-tightening and damaging the screws or components.
- What should I do if I have missing screws or parts?
- Contact the manufacturer or retailer where you purchased the chair for replacement parts.
- How do I ensure the chair is stable?
- After assembling, check all screws to make sure they are tight and ensure all parts are securely fastened.
- Is the chair suitable for outdoor use?
- Check the manufacturer’s recommendations, as this information is not provided in the assembly instructions.
Parts And Hardware

Assembly Instructions

Documents / Resources
References