CHUANGO logoRC-80
Remote Control
MULTILINGUAL
USER MANUAL

CHUANGO RC 80 Remote Control -

Introduction

RC-80 remote control is dainty and delicate, easy to carry. It can be attached to your key rings, or just put into your pockets or purses.
When you are about to exit or enter the house, you can use it to arm or disarm the system, In case of emergency, press the [SOS] button, and the alarm will be activated immediately.

Overview

CHUANGO RC 80 Remote Control - Overview

Connect Remote Control

Connecting the remote control is to build a wireless connection between the remote control and the control panel.

  1. The Control panel enters into the connecting state (For details, please refer to the relative user manual).
  2. Press any key on the remote control, and the control panel beeps once, indicating a successful connection.

Note: If the control panel beeps twice when the above operation is done, it means the remote control has been connected before.

Operating Instructions

Icon Operation Meaning
CHUANGO RC 80 Remote Control - Arm Arm Press this button, and the control panel beeps once, indicating the whole system is armed.
CHUANGO RC 80 Remote Control - Disarm Disarm Press this button, and the control panel beeps twice, then the system is disarmed except for those sensors in the 24-hour zone.
CHUANGO RC 80 Remote Control - Stay Stay Press this button, and all the sensors in home mode will enter disarm status. While other sensors remain in arm status, the user can move freely in the home zone.
CHUANGO RC 80 Remote Control - SOS SOS Press this button, the system will enter into the alarm state immediately.
CHUANGO RC 80 Remote Control - Mute Arm Mute Arm Press the [Stay CHUANGO RC 80 Remote Control - Stay] button for 1 second, wait until its indicator flashes once then press the [Arm CHUANGO RC 80 Remote Control - Arm] button within 3 seconds, and the system is armed silently.
CHUANGO RC 80 Remote Control - Mute Disarm Mute Disarm Press the [Stay CHUANGO RC 80 Remote Control - Stay] button for 1 second, wait until its indicator flashes once then press the [Disarm CHUANGO RC 80 Remote Control - Disarm] button within 3 seconds, the system is disarmed silently

Specifications

Power Supply: DC 3 V CR2025 Lithium Battery x 1
Transmit Current: <7 mA
Transmitting Distance: <80 m (Open area/no interference)
Radio Frequency: 433.92MHz
Housing Material: PC+ABS plastic
ERP(dBm).MAX: -14.81
Operation Condition:
Temperature: 0 °C ~ +55 °C
Relative Humidity: <80% (non-condensing)
Dimensions: 58 x 31 x 9.5 mm

CHUANGO DWC 102 Window Contact - 1

symbol Printed in China
Ver: RC-80-UM-ML-V1.0
© Chuango. All Rights Reserved.

Documents / Resources

CHUANGO RC-80 Remote Control [pdf] User Manual
RC-80 Remote Control, RC-80, Remote Control

References

Leave a comment

Your email address will not be published. Required fields are marked *