CC-KSTAND Double Braced X-Style Pro Series Keyboard Stand
MODEL: CC-KSTAND
KEYBOARD STAND ASSEMBLY
Parts Included: In order to form top to Bottom
-2ea. X-Braces -2ea. Upper Bars (Shorter)
-2ea. Lower Bars (Longer) -8ea. Hex Bolts
-1 Hex Key
-Adjustable wrench or pliers will be required (not included)
Loosen the center nut, and pull out the adjustment knob.
Pull and release the adjustment knob to secure the stand in an “X” position, as seen in this image. The adjustment knob must be inserted into the height adjust wheel.
Center nut must then be re-tightened.
Attach the 2 lower bars (longer) to each X-Brace by inserting 2 hex bolts through each bar, and tighten with the hex wrench. Repeat and attach the 2 upper bars (shorter) on the opposite end by inserting 2 hex bolts through each bar and tighten with the hex wrench.
Remove one of the rubber pads on the upper bars (shorter) to put the locking straps on if desired. Then put the rubber pad back on. Now you’re ready to play!
Documents / Resources
 |
CHROMACAST CC-KSTAND Double Braced X-Style Pro Series Keyboard Stand [pdf] User Guide CC-KSTAND Double Braced X-Style Pro Series Keyboard Stand, CC-KSTAND, Double Braced X-Style Pro Series Keyboard Stand, Pro Series Keyboard Stand, Keyboard Stand |
