Cell2 SQ4 – RC 4 LED LightHead

4-LED LIGHTHEAD 224 VDC

WIRING

• RED: To +VDC (fuse @ 3A)
• BLACK: To Chassis Ground
• WHITE: For steady burn, apply +VDC
• YELLOW: For Synchronization:
  Connect YELLOW wires of all heads together for synchronization (all heads must be set at the same pattern)
  For Simultaneous or Alternating Flash:
  1. Apply +VDC to RED and YELLOW wires Simultaneously to enter Grouping: lighthead will display short (single or double) flashes: Single flash Group1 Double flash Group2
  2. Momentarily apply +VDC to YELLOW wire to change Groups: Heads in the same Group flash together. Group1 Heads alternate with Group2 Heads. Double flash Group2
     For Flash Patterns:
     Momentarily apply +VDC to YELLOW wire:
     • once for next pattern
     • quickly three times for pattern 0

FLASH PATTERN

• Random
• Single (split)
• Double (split)
• Quad (split)
• Quint (split)
• Mega (split)
• Ultra (split)
• Single-Quad (split)
• Single H/L (split)
• Single (all)
• Double (all)
• Quad (all)
• Quint(all)
• Mega (all)
• Ultra (all)
• Single-Quad (all)
• Single H/L (all)
• Steady (ca)
• Steady 4 (all)

Note: This unit is not factory set at pattern 0

Documents / Resources

Cell2 SQ4 - RC 4 LED LightHead [pdf] User Manual SQ4 - RC 4 LED LightHead, SQ4 - RC, 4 LED LightHead, LightHead

References

• User Manual