Cell2 4 LED R65 Lighthead Recovery Emergency Flashing

4-LED R65 LIGHTHEAD
12-24 VDc

WIRING

• RED: To+VDC (fuse@ 1A)
• BLACK: To Chassis Ground
• WIHITE: To +VDC for steady-burn
• YELLOW: For Synchronization:
  Connect YELLOW wires of all heads together for synchronization (All heads should be set at the same Flash Pattern)
  For Simultaneous or Alternating Flash: 
  1. Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode;lighthead will display short (single or double) flashes:
     • Double flash = Group2
  2. Remove YELLOW wire from +VDC then momentarily apply it to +VDC to change Groups:
     • Heads in the same Group flash together.
     • Group1 Heads alternate with Group2 heads.
  3. Power-off to save and exit setting.
     For Flash Pattern:
     momentarily apply +VDC to YELLOW wire:
     • once for next pattern
     • quick three times to reset to FP#1

FLASH PATTERN

1. Single (2Hz)
2. Double (R65)
3. Triple (2Hz)
4. Quad (2Hz)
5. All Steady

NOTE: This unit may not be factory-set at Flash Pattern #1

Documents / Resources

Cell2 4 LED R65 Lighthead Recovery Emergency Flashing [pdf] User Manual 4 LED R65 Lighthead Recovery Emergency Flashing, 4 LED, R65 Lighthead Recovery Emergency Flashing, Recovery Emergency Flashing, Emergency Flashing, Flashing

References

• User Manual