Skydance V1-SP WT WiFi ug RF Dimming LED Controller

WiFi & RF Dimming LED Controller
- Mini WiFi + RF dimming single channel kanunay voltage LED controller.
- Tuya Smart APP cloud control, support on/off, brightness adjust, delay turn on/off light, timer run and scene edit function.
- Pagkontrol sa tingog, suporta alang sa Amazon Alexa, Google Assistant, Tmall Genie ug Xiaodu smart speakers.
- Match with RF 2.4G single-zone or multi-zone dimming remote controller optional.
- Each V1-SP(WT) controller can also work as WiFi-RF converter, then use Tuya smart APP to control one or more RF LED controller or RF LED dimming driver synchronously.
- Connect with external push switch to achieve on/off, and brightness 0-100% adjustment function.
- Logarithmic or linear dimming curves are available.
- 500Hz, 2KHz, 8KHz or 16KHz output PWM frequency selectable.
- 3s on/off fade can be set.
- Overheat/reverse/short circuit protection.
Teknikal nga Parameter
| Input ug Output | |
| Pagsulud voltage | 12-48VDC |
| Output voltage | 12-48VDC |
| Output kasamtangan | 6A@12/24V 5A@36/48V |
| Gahum sa output | 72W@12V 144W@24V 180W@36V 240W@48V |
| Kalibutan | |
| Temperatura sa operasyon | Ta: -20 OC ~ +55O C |
| Temperatura sa kaso (Max.) | Tc: +73O C |
| rating sa IP | IP20 |
| Pagdilim sa datos | |
| Input signa | WiFi + RF 2.4GHz + Push-DIM |
| Kontrola ang distansya | 30m (walay babag nga luna) |
| Pagdilim sa gray nga timbangan | 4096 (2^12) nga lebel |
| Dimming range | 0 -100% |
| Dimming curve | Linear/Logaritmic |
| Kadaghan sa PWM | 500Hz/2KHz/8KHz/16KHz |
| Garantiya ug Proteksyon | |
| Garantiya | 5 ka tuig |
| Proteksyon | Anti-reverse, overheat, short circuit |
| Kaluwasan ug EMC | |
| EMC nga sumbanan | EN IEC 55015/ EN IEC 61547-1/-2 ETSI EN 301 489-1/-17 |
| Sumbanan sa kaluwasan | EN 61347-1/-2 |
| Kagamitan sa radyo | ETSI EN 300 328 ETSI EN 300 440 |
| Sertipikasyon | Mga CE RoH |
| Pakete | |
| Gidak-on | L60 x W60 x H40mm |
| Gross nga gibug-aton | 0.043kg |
Mekanikal nga mga Istruktura ug Pag-instalar

Mubo nga sulat: The mounting ear on both sides can be broken along the indentation, to suit different mounting needs.
Wiring Diagram

Pag-andam sa wire:
- Ang mga kable mahimong solid o ma-stranded nga adunay cross-sectional area nga 0.5 hangtod 2.0 mm².
Ang naandan nga 1mm² makasugakod sa 10A output nga kasamtangan. - When wiring is installed, the terminals must be tightened. If they are not tightened, the contact point resistance will be too high
and the terminals will easily burn due to heat when used at full load for a long time
Mubo nga sulat: Ang output nga gahum sa usa ka kanunay nga voltage power supply kinahanglan nga labing menos 1.2 ka pilo sa output load (LED strip), kon dili ang bug-os nga gahum output sa load dali rang hinungdan sa automatic ickering o pag-uyog sa kahayag.
Sistema nga Wiring

Panel RF Remote (Opsyonal)
Mubo nga sulat:
- Ang gilay-on sa ibabaw gisukod sa lapad (walay babag) nga palibot, palihog tan-awa ang aktuwal nga gilay-on sa pagsulay sa dili pa i-install.
- Palihug susiha kung ang WiFi router net sa 2.4G band, ang 5G band wala magamit, ug ayaw itago ang imong router network.
- Please keep the distance between V1-SP(WT) devices and router close, and check the WiFi signals.
Push Switch Dimming
Ang interface sa push switch mahimong konektado sa push panel switch o push button para sa dimming.
- Mubo nga press: I-on o i-off ang suga.
- Doble nga pag-klik: Switch between 10% and 100% brightness.
- Long press (1-6s): Continuously increase or decrease the brightness, long press again after each release, the brightness changes in the opposite direction.
- Pagdilim sa memorya: The brightness value has been set by long-pressing Push, with power-down memory.
- I-synchronize: If multiple controllers are connected to the same self-reset switch, please long press for 10s first to synchronize all lights to 100% brightness.
It is recommended that the number of controllers connected to the same push switch does not exceed 25, and the length of the connecting wire does not exceed 20m.
Tuya Smart APP Network Connection
Pag-download ug ablihi ang APP
Pangitaa ang “Tuya Smart/Smart Life APP” in the app store, or scan the QR code on the right to download the APP.
Register and login after installation.
![]() |
![]() |
APP Pairing Network
Push twice SET key fastly, or press and hold SET key for 5s, or repeat power off and on for 5 consecutive times fastly, enter WiFi config mode, RUN LED indicator flash fastly, the output LED strip blinks 10 times.
If Tuya smart APP network connection succeed, RUN LED indicator will stop ash.
You can find DIM device in Tuya smart APP.

Kung gikontrol ang suga gamit ang Tuya Smart / Smart Life APP, kung ang koneksyon sa network dili maayo, mahimo nimong makontrol ang suga nga adunay koneksyon sa Bluetooth sa sulod sa kontrol sa Bluetooth.
But the light can not be directly controlled by Bluetooth without WiFi conguration.
Ipares sa RF Remote Control
Adunay duha ka paagi sa pagpares/pagtangtang:
Gamita ang match key
Tugma:
Short press match key, enter the match state.
immediately press on/off key (single zone remote) or zone key (multiple zone remote) of the remote, The LED indicator fast flash means match is successful.
Pagtangtang:
Press and hold match key for 10s to delete all match, The LED indicator fast flash means all matched remotes were deleted.
Gamita ang Power Restart
Tugma:
Ipalong ang gahum, dayon i-on ang gahum, balika pag-usab.
Diha-diha dayon pugngi ang on/off key (single zone remote) o zone key (multiple zone remote) 3 ka beses sa remote.
The output light flashes 3 times means match is successful.
Pagtangtang:
Ipalong ang gahum, dayon i-on ang gahum, balika pag-usab.
Diha-diha dayon pugngi ang on/off key (single zone remote) o zone key (multiple zone remote) 5 ka beses sa remote.
The output light flashes 5 times means all matched remotes were deleted.
Pagtrabaho isip WiFi-RF Converter
Ang V1-SP(WT) mahimong molihok isip WiFi-RF converter, gipares sa RF LED controller o RF dimmable LED driver, Adunay duha ka paagi sa pagpares/pagtangtang:
Gamita ang yawe sa Controller
Tugma:
Short press controller’s match key, immediately press the on/off button on the Tuya Smart APP.
The LED indicator fast flash means match is successful.
Pagtangtang:
Long press controller‘s match key for 5s to delete all match.
The LED indicator fast flash means all matched remotes were deleted.
Use Power Restart(optional)
Tugma:
I-off ang gahum sa controller, dayon i-on ang gahum, balika pag-usab.
Immediately press the on/off button on the Tuya Smart APP 3 times. The light flashes 3 times means match is successful.
Pagtangtang:
I-off ang gahum sa controller, dayon i-on ang gahum, balika pag-usab.
Immediately press the on/off button on the Tuya Smart APP 5 times.
The light ashes 5 times means all matched remotes were deleted.
PWM Frequency Setting
Four PWM frequencies can be selected: 500Hz, 2KHz, 8KHz or 16KHz.
Higher PWM frequency will result in lower output current, higher power supply noise, more suitable for camera shooting (video without flicker).

Pag-set sa Dimming Curve
Linear Dimming Curve

Logarithmic Dimming Curves

Pag-on/Pag-off sa Fade Time Setting
Press and hold the SET key for 15s to restore the default parameters, factory default parameters: light on/off fade time is 0.5s.
Press and hold the SET key for 20s, the light on/off fade time is set to 3s.
Mga Pag-amping sa Pag-instalar
- Ang mga produkto kinahanglan nga dili stacked, ang gilay-on kinahanglan nga ≥ 20cm, aron dili makaapekto sa lifespan sa mga produkto tungod sa dili maayo nga pagkawala sa kainit.
- Ang produkto dili i-install duol sa switching power supply nga adunay interval nga ≥ 20cm aron malikayan ang radiation interference sa switching power supply.
- The installation height shall be ≥ 1m from the oor to avoid shortening remote control distance due to too weak reception signal.
- Ang mga produkto dili tugotan nga duol sa o gitabonan sa metal nga mga butang, nga adunay agwat sa ≥ 20cm aron malikayan ang signal attenuation ug mub-an ang layo nga distansya.
- Likayi ang pag-instalar sa eskina sa bungbong o sa eskina sa sagbayan, nga adunay interval nga ≥ 20cm aron malikayan ang pagkabalda sa signal.

Mga Dokumento / Mga Kapanguhaan
![]() |
Skydance V1-SP WT WiFi ug RF Dimming LED Controller [pdf] Manwal sa Gumagamit V1-SP WT, V1-SP WT WiFi ug RF Dimming LED Controller, V1-SP WT, WiFi ug RF Dimming LED Controller, RF Dimming LED Controller, LED Controller, Controller |




