I-install ang Cisco Catalyst Network Interface Module
Kini nga seksyon naghatag kasayuran sa wala pa ug sa panahon sa pag-instalar sa Cisco Catalyst Network Interface Modules (NIMs) sa Cisco Catalyst 8200 Series Edge Platforms.
Tapos naview sa Network Interface Module
The Cisco Catalyst Network Interface Module (NIM) is supported on Cisco Catalyst 8200 Series Edge Platforms.
These are the steps to install a NIM:
1. Pangitaa ang slot sa NIM sa atubangan nga panel.
2. Loosen the screws to remove NIM blank cover.
3. Isulod ang NIM sa slot.
4. Hupti ang mga screw aron masiguro ang NIM sa slot.
These are the steps to remove a NIM:
1. If the NIM is up and running, issue the following command to shut down the NIM gracefully before removing it:
hw-module subslot slot 0/2 stop
Pagbantay If you do not shut down the NIM gracefully before removing it, the NIM card could get damaged.
2. Pangitaa ang slot sa NIM sa atubangan nga panel.
3. Luwasa ang mga screw nga nagsiguro sa NIM.
4. Hinayhinay kuhaa ang NIM gikan sa slot.
All module slots must have a module or blank installed for the product to work thermally and for safety purposes.
Para sa dugang nga impormasyon, tan-awa ang Cisco Catalyst 8200 Series Edge Platforms datasheet sa cisco.com para sa listahan sa mga gisuportahan nga NIM sa mga plataporma.
Kuhaa ug I-install ang Network Interface Module
Keep the following tools and equipment while working with the Network Interface Modules (NIM)s:
- Numero 1 Phillips screwdriver o gamay nga flat-blade screwdriver
- Strap sa pulso nga malikayan sa ESD
Kuhaa ang Network Interface Module
Lakang 1 Shut down the electrical power to the slot in the device, turn off the electrical power to the device. Leave the power cable plugged-in to channel ESD voltages sa yuta.
Lakang 2 Remove all network cables from the rear panel of the device. Using a number 1 Phillips screwdriver, loosen the captive screws on the network interface module.
Lakang 3 Slide the network interface module out.
Lakang 4 If you are not replacing the module, install a blank faceplate over the empty slot to ensure proper air flow.
I-install ang Cisco Catalyst Network Interface Module
Lakang 1 Shut down the electrical power to the slot in the router by turning off the electrical power to the router. Leave the power cable plugged in to channel ESD voltages sa yuta.
Lakang 2 Remove all network cables from the rear panel of the device.
Lakang 3 Remove the blank faceplates installed over the network interface module slot that you intend to use.
Nota Save blank faceplates for future use.
Lakang 4 Align the module with the guides in the chassis walls or slot divider and slide it gently into the NIM slot on the device.
Lakang 5 Push the module into place until you feel the edge connector seat securely into the connector on the router backplane. The module faceplate should contact the chassis rear panel.
Lakang 6 Using a number 1 Phillips screwdriver, tighten the captive screws on the network interface module.
Lakang 7 Connect the module to the network and re-enable the power to the slot in the device.
I-install ang Cisco Catalyst Network Interface Module
Mga Dokumento / Mga Kapanguhaan
 |
CISCO 8200 Series Catalyst Network Interface Module [pdf] Giya sa Gumagamit 8200 Series, 8200 Series Catalyst Network Interface Module, Catalyst Network Interface Module, Network Interface Module, Interface Module |