Testex provides Press-O-Film replica tape, digital micrometers and burnishing tools for measuring surface profiles on roughened steel during coating preparation.
Testex provides Press-O-Film replica tape, digital micrometer thickness gages and burnishing tools for measuring surface profiles on roughened steel.
Browse Testex manuals for tape-grade selection, instrument setup, cleaning, zeroing, measurement averaging and data export. Match your instrument model to the appropriate guide before use.
Selected manuals from manuals+ curated for this brand.
Common questions about manuals, registration, and support for this brand.
Match the model identifier on your instrument with the manual title. Available guides include RTMMIL and RTM digital micrometers and an RTXC-titled instruction manual.
Clean the anvils before powering on or zeroing the gage, then select the correct replica tape grade. Follow your model's instructions for conversion settings; Coarse Minus tape requires HL mode to be disabled.
Take at least two measurements at each location. If they differ by no more than 5 microns (0.2 mils), record their average. Otherwise, take a third measurement and average the two closest readings.
The supplied digital micrometer instructions describe USB-C connection and USB Drive Mode for CSV export. Stored readings can also be downloaded to PosiSoft Desktop Software.
Use the Sales & Support page at https://www.testextape.com/sales. The listed technical sales support hours are 8am–5pm EST.