SATRAN Manuals & User Guides

SATRAN MK1 Antenna Rotator Instruction Manual

July 3, 2026

MK1 Antenna Rotator MK1 Assembly Instructions Specifications Screws: M3x6, 3x10mm, 2x10mm, 2.5x6mm, M3x8 Bearings: Metal bearing balls Gears: Large worm gear, small worm gear, cogwheel Motor: Stepper motor Other components:…

SATRAN MK-2 Antenna Rotator Instruction Manual

July 3, 2026

SATRAN MK-2 Antenna Rotator Specifications Screws: M3x6, 3x10mm, 2x10mm, 2.5x6mm, M3x8 Bearings: Metal bearing balls Gears: Large worm gear, small worm gear, cogwheel Motor: Stepper motor Other components: Limit switch,…

SATRAN MK-1 Antenna Rotator Instructions

July 3, 2026

SATRAN mk 1 bill of materials www.danaco.se 2021-02-22 x 1 Circuit holder x 1 Base mount x 1 Bottom plate x 1 Turntable x 1 Top plate x 1 Antenna…

SATRAN MK3 Azimuth Elevation Satellite Antenna Rotator User Manual

July 3, 2026

SATRAN MK2 USER MANUAL "SAtellite TRacking ANtenna" Experimental azimuth/elevation antenna rotator www.satran.io     Within Europe only legal for use by authorities or licensed radio amateurs. Always read and understand this…

SATRAN MK3 Antenna Rotator Hardware Kit Instructions

July 3, 2026

SATRAN MK3 Antenna Rotator Hardware Kit Specifications Component Specifications Bolts M5, M3x6mm, 3x10mm Nuts Hex, M8, Flange Screws 2.2mm, Countersunk INSTALLATION INSTRUCTION Unpack the kit and make sure all parts…

SATRAN MK2,MK3 Remote Automatic Antenna Rotator Installation Guide

July 2, 2026

SATRAN MK2, MK3 Remote Automatic Antenna Rotator Specifications Model: Satran MK2 Elevation Manufacturer: Satran Website: www.satran.io Last Updated: 2022-07-02 Usage Instructions Prepare the Elevation Sensor: Rotate the elevation sensor to…

SATRAN MK2/MK3 Firmware Wifi-Controlled Satellite Antenna Instructions

July 2, 2026

SATRAN MK2/MK3 Firmware Wifi-Controlled Satellite Antenna Specifications Chip Type ESP8266 Work Mode Develop Load Mode UART Hex Target Address 0x0 Instructions Download the latest binary firmware from Satran Downloads and install the…

SATRAN MK3 Satellite Tracking Antenna Rotator User Manual

July 2, 2026

SATRAN MK3 Satellite Tracking Antenna Rotator Specifications MK3 Control unit processor: ESP8266 v2 Node MCU Recommended PSU: DC12V 1A Control unit power cable: JST-XH 2pin to 5x2.5mm DC-plug Voltage requirements:…

Satran MK1 Antenna Rotator Assembly Instructions

assembly instructions

Step-by-step assembly guide and WiFi setup process for the Satran MK1 antenna rotator. Learn how to build and configure your satellite tracking system.

Satran MK1 Antenna Rotator Assembly Instructions

assembly instructions

Comprehensive assembly and setup guide for the Satran MK1 antenna rotator. Includes step-by-step instructions for mechanical assembly and WiFi configuration.

Satran MK2 Elevation Assembly Guide

assembly instructions

Step-by-step assembly instructions for the Satran MK2 elevation unit, including sensor alignment, motor installation, and housing assembly.

Satran MK-3 Antenna Rotator Assembly Instructions

assembly instructions

Step-by-step assembly guide for the Satran MK-3 antenna rotator system, covering mechanical assembly, motor installation, and mounting procedures.

Satran MK2 Satellite Tracking Antenna User Manual

manual

Comprehensive user manual for the Satran MK2 experimental azimuth/elevation antenna rotator. Includes setup, mounting, calibration, and control instructions.

Satran MK3 Satellite Tracking Antenna User Manual

manual

Comprehensive user manual for the Satran MK3, an experimental 3D-printable azimuth/elevation antenna rotator. Includes assembly, calibration, and software control instructions.

Updating the Satran MK2/MK3 Firmware Guide

instruction

Step-by-step instructions for updating the firmware on Satran MK2 and MK3 antenna rotators using the Espressif Flash Download Tools.

SATRAN MK3 Rotator Bill of Materials

parts list diagram

Comprehensive bill of materials and 3D-printable parts list for the SATRAN MK3 Rotator, including electronic components, fasteners, and structural parts.