KMC Controls manufactures open, secure, and scalable building automation solutions, including HVAC controllers, thermostats, sensors, and actuators for commercial facility management.
KMC Controls is an American manufacturer dedicated to designing and producing open, secure, and scalable building automation and technology solutions. Since 1969, the company has provided innovative hardware and software for the HVAC and building control industry. KMC Controls specializes in optimizing energy usage, ensuring occupant comfort, and improving safety through a diverse product lineup that includes the FlexStat and AppStat series of thermostats, unparalleled analog and digital sensors, and robust electromechanical actuators.
Headquartered in New Paris, Indiana, KMC Controls prides itself on its 'Building Geniuses' team and a commitment to backward compatibility and open standards like BACnet. Their products range from enterprise-level IoT platforms to field-level controllers, serving schools, hospitals, office buildings, and industrial facilities worldwide.
Latest manuals from manuals+ curated for this brand.
Watch setup, installation, and troubleshooting videos for this brand.
Common questions about manuals, registration, and support for this brand.
On the FlexStat display, navigate to the setpoint using the Up/Down buttons, press Enter to select, adjust the value, and press Enter again to confirm.
False detections can be triggered by sudden temperature changes, direct sunlight, incadescent light exposure, or small animal movements near the sensor.
KMC recommends using 18 to 24 AWG shielded wiring for sensor connections. Do not run sensor wires in the same conduit as inductive loads.
With power applied, flip the Direction switch from its current position to the opposite to initiate reset. The actuator will move to the CCW limit. Return the switch to the original position before the reset finishes to complete the process.
Turn the two hex screws on the backplate clockwise until they clear the cover, then swing the thermostat up and away to remove it from the base.