Cell2 Manuals & User Guides

24VDC 6-Led Narrow Profile Lighthead Installation Guide 12-24VDC 6-Led Narrow Profile Lighthead Wiring / Operation Connect YELLOW wires of all heads together for synchronization. (All heads should be set to…

Cell2 AL6 Wide Angle Lighthead Surface Mounting WIRING OPERATION For Simultaneous or Alternating Flash: Apply +VDC to RED and YELLOW wires simultaneously to enter Grouping mode; lighthead will display short…

Cell2 HALO-BLITZ Halo Ring 6LED Warning Lighthead 6LED WARNING LIGHTHEAD W/ HALO-RING™ WIRING OPERATION For Warning Synchronization: Connect YELLOW wires of all light heads together for synchronization.(All light heads should…

Cell2 SL209 Exterior Scene Light SL209 Exterior Scene Light Manual WIRING:  INSTALLATION Place the foam pad onto the desired mounting surface and mark the location for the two mounting screws…

Cell2 WLJ 3-Inch Round Compartment Light User Manual WIRING: To +VDC (fuse rating @ 1A)............................... RED To -Chassis Ground................................................ BLACK INSTALLATION: (Included mounting kit will be based on the actual…

WLJ-DC 3 Inch Round Compartment Light User Manual WLJ-DC 3 Inch Round Compartment Light WIRING: illumination Lightheaded - Multi-Colour Edition To Vehicle -Ground...............................LACK To +VDC for Colour 1 activation (fuse…

WLK 8-inch Round Interior Light User Manual WLK 8-inch Round Interior Light To properly install this light, you must have a good understanding of automotive electrical procedures and systems, along…

EDGESABER-SHROUD Edge saber Mount Kit User Manual Windshield Shroud Kit MANUAL 86-M5910-0201.0 INSTALLATION Assemble the lightheaded to the plastic shroud with the rubber backing. Adjust the angle of the lightheaded…

Cell2 HAL09W Undercover LED Kit WIRING 2 KITS TOGETHER In this wiring illustration, different alternating flash patterns can be achieved. If a “split” flash pattern* is selected: Heads 1 &…

86-M07710-0001.0 DUAL COLOUR   3+3 LED DUAL COLOUR LIGHTHEAD WIRING To Chassis Ground:...................................... BLACK To+VDC for Warning Mode (1) (fuse @ 1A):......... RED Default Colour Mode - Colour 1 To+VDC for…