Brookside Urban Vinyl Click Plank Flooring Instruction Manual
Urban Vinyl Click Plank Flooring FLOOR FACTORY Before you start installation of this flooring product, please thoroughly read these Owner/Purchaser/Installer Responsibilities and Installation Instructions: By starting the installation of your FLOOR FACTORY floor installation, you are agreeing that you? have read and understand all Owner/Purchaser/Installer requirements and responsibilities and are aware that deviating from the instructions and recommendations in this installation? guide may result in voiding the product's warranty. It is the sole responsibility on the Owner/Purchaser/Installer, prior to installation, to verify that the area/environment planned for installation is suitable for FLOOR FACTORY flooring and meets all local building codes and that all subflooring is dry, sound, flat and clean and meets or exceeds all industry standards; as well as the recommendations listed herein. The manufacturer and distributor accept no responsibility for product failure extending from or related to failure to meet job area/environment and subflooring requirements. The Owner/Purchaser/Installer assumes full responsibility for the final inspection of this product. Inspection should be done prior to installation and should include: color, factory finish, milling and/or locking system damages. If the product is not acceptable, DO NOT install it. Contact your supplier immediately for assistance. This FLOOR FACTORY flooring warranty DOES NOT cover materials with visible defects after they are installed. This product may be installed over a radiant heating system, the system must an imbedded type (circulating or electric)and be a minimum of 1/2" (12mm) below the subfloor installation surface and never indirect contact with the FLOOR FACTORY floor. Temperature must never exceed 90°F(32°C)and changes in temperature settings must be gradual. It is the responsibility of Owner/Purchaser/Installer to confirm the suitability of the radiant heating system for use with this product. The selection and use of any radiant heating system is the choice and sole responsibility of the Owner/Purchaser/Installer. Certain condominium and other multi unit type building associations and/or owners may have floor covering acoustic performance requirements that may exceed the acoustic performance levels of this product, thereby requiring that a supplemental acoustical underlayment is required. If required by your condo association, this product may be installed over a supplemental…
