Cargo Systems V0038 LED Monitor Set
Connection diagram of the display
Step 1. Connect the positive, negative and ACC wires from your car battery to the display
Step 2. Install the display on your rooftop cross bar
How to Use the Display
Create your own account:
Step 1. Visit our AIPS platform at https://www.ledaips.com
Register an account by clicking Join in below picture or you may use our test account below for a brief visit.
Admin Account: dreamTaxiTest
Admin Password: dreamTaxiTest
Step 2. After logging in, you will see the functions shown in below picture of which we will walk you through some major functions so as to get yourself acquainted with the system.
Play media on your display
Step 1. Upload your media files by following the menu path: Media‐> Upload media file(s)
Wait till the file(s) finishes
Step 2. Create a program by following the menu path: Programs ‐> Add simple program In the popup window, set display pixel sizes at 384 for Width and 128 for Height.
Step 3. Choose the images and click + to add them to the program. On the right of the window, set a name for the program and click Save.
Step 4. Create program task by following the menu:
Programs ‐> Example(The program we just added) ‐> Create Task quickly
Step 5. Send Program by following the menu:
Terminal Control ‐> Choose the terminal ‐> Programs Task ‐> Click Send the Program task
Send task based on GPS
Step 1. Choose the map.
Step 2. Add GPS play point by clicking the location on the map.
Set Name of GPS Task Name. Choose the media, input Name and radius.
Step 3. Save the GPS task.
Step 4. Send GPS task by following the menu:
Terminal Control ‐> Choose the terminal ‐> GPS Task ‐> Click Send the Program task
|Dimension:||986mm(W) x 390mm(H) x 98mm(T)|
|Color Choice:||Silver, golden|
|Input Voltage & Current :||9~36V⎓ 34A~8A|
|WCDMA‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐Band 2/ Band 5 FDD_LTE‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐Band 2/ Band 4/ Band 12|
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Documents / Resources
|Cargo Systems V0038 LED Monitor Set [pdf] User Manual|
V0038, 2A3DA-V0038, 2A3DAV0038, V0038, LED Monitor Set