Cambridge Audio TV5 SPEAKER BASE WITH BLUETOOTH
TV5 Speaker Base with Bluetooth
PLACEMENT
TV5 is designed to be placed under your TV. The TV must have a base no wider than 725mm (28.5”) and no deeper than 300mm (12”) and must weigh no more than 30kg (66lbs). If the TV base is too large to fit, place TV5 on a lower shelf of your TV rack
TV CONNECTIONS
- Only one audio connection to your TV is required, in order of preference:
- ARC: If your TV has a socket labelled ARC use this connection.
- Optical: If available on your TV, use this for best quality.
- RCA: Connect both left and right channels to your TV.
- AUX In: Connect to the headphone output of your TV if neither
ARC or optical are available on your TV.
LEARNING YOUR TV REMOTE
Remove the fabric grille and locate the control panel. Follow the instructions remembering to point your TV remote at the control panel whilst learning.
BLUETOOTH SET-UP
TV5 is equipped with Bluetooth to allow wireless playback from any Bluetooth-equipped phone, tablet or computer.
- Select the Bluetooth input
on the remote. - To connect a Bluetooth device to TV2, press and hold the button and the Blue LED
will blink. - Consult the instructions of the Bluetooth device to connect to TV5 Successful pairing will be signalled by a ‘beep’ from the unit and the Blue LED will stop flashing.
- Once paired, music from your device will play through the unit.
- To add another Bluetooth device, repeat from step 2.
- TV2 will store up to 8 paired devices in memory
TOP TIPS
AUTO POWER DOWN
To save power, TV5 will automatically turn off after a few seconds if no sound is playing from your TV.
AUTO POWER ON
When you turn on your TV, TV2 will detect the sound and automatically turn on.
SOUND MODES
There are 4 different modes that can be selected to enhance your sound experience. You can also Increase or decrease the Subwoofer output.
- TV: Greatly improved TV sound
- Music: Enhances stereo music and music videos.
- Film: Designed to get the best sound from movies.
- Voice: Enhances voices to improve intelligibility.
IMPORTANT SAFETY INSTRUCTIONS
For your own safety please read the following important safety instructions carefully before attempting to connect this unit to the mains power supply. They will also enable you to get the best performance from and prolong the life of the unit:
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
Follow all instructions. - Do not use this apparatus near water.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power-supply cord or plug having been damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE AND OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHOULD NOT BE PLACED ON THIS APPARATUS.
WEEE SYMBOL
The crossed-out wheeled bin is the European Union symbol for indicating separate collection for electrical and electronic equipment. This product contains electrical and electronic equipment which should be reused, recycled or recovered and should not be disposed of with unsorted regular waste. Please return the unit or contact the authorised dealer from whom you purchased this product for more information.
CE MARK
This product complies with European Low Voltage (2014/35/EU), Electromagnetic Compatibility (2014/30/EU) and Environmentally-friendly design of Energy-related Products (2009/125/EC) Directives when used and installed according to this instruction manual. For continued compliance only Cambridge Audio accessories should be used with this product and servicing must be referred to qualified service personnel.
VENTILATION
IMPORTANT – The unit will become hot when in use. Do not stack multiple units on top of each other. Do not place in an enclosed area such as a bookcase or in a cabinet without sufficient ventilation. Ensure that small objects do not fall through any ventilation grille. If this happens, switch off immediately, disconnect from the mains supply and contact your dealer for advice. Please ensure there is ample ventilation (at least 20cm clearance on the top, side and rear). Do not put any objects on top of this unit. Do not situate it on a rug or other soft surface and do not obstruct any air inlets or outlet grilles. Do not cover the ventilation grilles with items such as newspapers, tablecloths, curtains, etc.
POSITIONING
Choose the installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. No naked flame sources, such as lighted candles, should be placed on the unit. Also avoid locations subject to vibration and excessive dust, cold or moisture. The unit can be used in a moderate climate. This unit must be installed on a sturdy, level surface. Do not place in a sealed area such as a bookcase or in a cabinet. Do not place the unit on an unstable surface or shelf. The unit may fall, causing serious injury to a child or adult as well as serious damage to the product. Do not place other equipment on top of the unit. Due to stray magnetic fields, turntables or CRT TVs should not be located nearby due to possible interference. Electronic audio components have a running in period of around a week (if used several hours per day). This will allow the new components to settle down and the sonic properties will improve over this time.
POWER SOURCES
The unit should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power-supply to your home, consult your product dealer or local power company. This unit can be left in Standby mode when not in use and will draw <0.5W in this state. If you do not intend to use this unit for a long period of time, unplug it from the mains socket.
OVERLOADING
Do not overload wall outlets or extension cords as this can result in a risk of fire or electric shock. Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation and broken plugs are dangerous. They may result in a shock or fire hazard. Be sure to insert each power cord securely. To prevent hum and noise, do not bundle the interconnect leads with the power cord or speaker leads.
CLEANING
To clean the unit, wipe its case with a dry, lint-free cloth. Do not use any cleaning fluids containing alcohol, ammonia or abrasives. Do not spray an aerosol at or near the unit.
BATTERY DISPOSAL
Batteries may contain substances harmful to the environment. Please dispose of any discharged batteries with due consideration and in accordance with local environmental/electronic recycling guidelines.
SERVICING
These units are not user serviceable. Never attempt to repair, disassemble or reconstruct the unit if there seems to be a problem. A serious electric shock could result if this precautionary measure is ignored. In the event of a problem or failure, please contact your dealer.
FCC
FEDERAL COMMUNICATIONS COMMISSION NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
FCC RADIATION EXPOSURE STATEMENT:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
MODIFICATIONS
The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by Cambridge Audio, may void the user’s authority to operate the equipment.
CANADA-INDUSTRY CANADA (IC)
This radio transmitter has been approved by Industry Canada. This Class B digital apparatus complies with Canadian standard ICES-003. This device complies with Industry Canada License exempt RSS standard(s). Operation is subject to the following two conditions.
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. The transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
EUROPE-EUROPEAN UNION NOTICE
Radio products with the CE alert marking comply with the RED Directive (2014/53/EU) issued by the Commission of the European Community. Compliance with this directive implies conformity to the following European Norms.
- EN 60065 – Product Safety.
- EN 300 328 – Technical requirement for radio equipment.
- EN 301 489 – General EMC requirements for radio equipment.
FAQS
The short answer is yes. You can find quality wireless subwoofers from several brands today, which means you have options if this is something you want to purchase. This is true regardless of if you want a small bluetooth subwoofer, one for your home, or a bluetooth subwoofer for a car
The placement of a Bluetooth or wireless speaker also has a major impact on the reproduction of the low frequencies. Indoors, you can easily boost the bass by placing the speaker up against a wall or, even better, in a corner. The wall will reflect and artificially amplify the low frequencies
By choosing a Bluetooth adapter to make them Bluetooth enabled, you can connect your smartphone, laptop, and even television to them, making it easy to use them to stream music, movies, podcasts, and other audio.
What is a Subwoofer? In the words of Meghan Trainor, a subwoofer is all about that bass. It’s the speaker that delivers the lower frequencies – specifically 20-200 Hz – that a traditional two-channel or surround sound setup can’t reproduce on its own
In most situations, Bluetooth will not have a significant impact on the sound quality of an audio device
The difference between Bluetooth and Wi-Fi speakers is that Bluetooth speakers tend to be better for smaller spaces and are very portable. Wi-Fi speakers have better range, sound quality, and are less likely to have their signal interrupted, but usually need to be connected to power at all times
All you need is a simple Bluetooth adapter. There are dozens of affordable options. Pick one, hook it up, pair it with your phone, and then any audio coming out of your device can be floated wirelessly to your speakers
Depending on the equipment you have, you may be able to connect to two Bluetooth speakers simultaneously. Newer technology comes equipped with Bluetooth 5 which allows you to pair with two devices at once. Other device manufacturers have developed their own similar solutions
Bluetooth 5.1 has tons of features and new builds from Bluetooth 5.0 but there are only several features that are truly worth noting. To be more exact, 5.1 has more accurate tracking, GATT caching enhancements, and advertising sync transfer.
Yes. You can use Bluetooth without Wi-Fi. In fact, Bluetooth does not need any internet access at all to be set up and used. However, you will find many Bluetooth devices are also capable of connecting to the internet
Bluetooth Audio transmitters are a lifesaver for both modern-day and older technology. Transmitters are the perfect way to go when you’re looking to send Bluetooth sound from a television to a wireless device.
Tap the small button at the top right of the player notification tile. In the media player pop-up, you’ll see a list of connected audio devices. Tap the one you want to switch to
Up until recently, though, Bluetooth can be used to connect multiple speakers to one device. With the help of Bluetooth 5.0 and the AmpMe app, you can expand the number of Bluetooth connections on your device. It is also possible to connect multiple Bluetooth speakers via JBL Connect, Bose Connect, and Ultimate Ears
In general, In general, host devices support up to 7 simultaneously connected devices and a practically unlimited number of paired. Client devices typically support a limited number of pairings, anywhere between 1 and 5, and only one single connection
Up until recently, though, Bluetooth can be used to connect multiple speakers to one device. With the help of Bluetooth 5.0 and the AmpMe app, you can expand the number of Bluetooth connections on your device. It is also possible to connect multiple Bluetooth speakers via JBL Connect, Bose Connect, and Ultimate Ears.
