CALIMET CM9-976 Digital Timer Switch
Specifications
- Model: CM9-976 Digital Timer Switch
- Power Supply: 24V DC
- Operating Mode: Auto/Manual
- Programming: Weekly schedule
Digital Timer Wire Connection
Refer to the following diagram for the wire connection:
Setting Weekly Schedule
- Press the WEEK button to select the desired day(s) of the week.
- Use the HR (hour) and MM (minute) buttons to set the desired time.
- Select ON or OFF for the scheduled event.
Switching between Auto and Manual Mode
To switch between Auto and Manual modes, press the AUTO/MANUAL button on the device.
Safety Features
The device is equipped with safety features such as phantom open/loop detection for added security.
Program Digital Timer
- Use a pin and press “C”, once the digital screen is reset.
- Press “D+” to set the current day, “H+” hour, and “M+” minute.
- Press “
” after finishing setting the date and time. - Press “P” to select program setting 1 (total of 28 program settings). The user should see “1 ON” (opening time). Press “D+” to set the days that are needed, “H+” for the hour, and “M+” for the minute.
- Press “P” again to select the program setting “1 OFF” (closing time). Press “D+” to set the days that are needed, “H+” for the hour, and “M+” for the minute.
- Follow Setp 4 and 5 until finish programmed the timer.
- Press “” aftthe er finish.
NOTE: To disable the digital timer, click on “Manual”.
FAQS
Q: How do I reset the timer to factory settings?
A: To reset the timer to factory settings, press and hold the RESET button for 10 seconds.
Q: Can I program multiple schedules for the same day?
A: Yes, you can program multiple schedules for the same day by following the steps for setting a weekly schedule repeatedly.
Documents / Resources
 |
CALIMET CM9-976 Digital Timer Switch [pdf] Instructions CM9-976 Digital Timer Switch, CM9-976, Digital Timer Switch, Timer Switch, Switch |