CALEX 4301003103 Vista String Lights
Specifications
- Model Numbers: 01, 02, 04, 05, 07, 10, 14, 16 (IP54), 18, 30, 32, 33, 34, 35, 36, 37
- Dimensions: 1 x 77 x 3H
- IP Rating: IP20 (IP23)(IP44) (IP54)
- Max. Power Consumption: M MAX. … W
- Type: XYZ
This manual, A, contains descriptions of all necessary steps for assembling and installing this product. Refer to the icons in the supplementary manual, B, to see which of the following points apply to this product:
- 01, 02, 04, 05, 07, 10, 14, 16 (IP54), 18, 30, 32, 33, 34, 35, 36, 37
- 3H:
Press the button to adjust the product to a 3-hour timer mode, a nd the product will turn off after 3hours. - 5H
Press the button to adjust the product to a 5-hour timer mode, and the product will turn off after 5hours. - ON/OFF:
In constant light mode, press the button once to turn off the product, then press the button again to turn on the product. - 25%
In static mode, press the button to adjust the brightness to 25% - 50%
In static mode, press the button to adjust the brightness to 50% - 75%
In static mode, press the button to adjust the brightness to 75% - 100%
In static mode, press the button to adjust the brightness to 100% - -：
Press the button under the scene mode, speed up. - +：
Press the button under the scene mode, slow down. - Steady on：
Press the button, and the product will enter a static constant light state from other modes. - Pulse：
Press the button, the color of the product changes from dark to bright, then to dark, and finally. - Flash：
Press the button, and the product will flash rapidly and intermittently.
This manual, B, contains descriptions of all parameters, specifications, and relevant icons in accordance with international standards and safety regulations. However, these do not always apply to the product you purchased. Refer to the icons in the supplementary manual, A, to see which of the following points apply to this producBeforeree installing this product, check which plugs and screws are best suited for the intended surface.
- Do not connect the product to a power supply while it is still in the package.
- Do not connect the product to a power supply while it is wound onto a reel.
- do not use the product when covered or recessed into a surface;
- Do not open this product.
- Safety Class I: this product must be connected to an earthed socket; the luminaire is equipped with a ground terminal and must therefore be earthed; connect the ground wire (yellow green vein) to the
1-marked terminal. - Safety Class II: This product is double-insulated and does not need to be connected to an earthed socket.
- Safety Class III: this product is only suitable for very low safety voltage (e.g., 12V)
- Intended use: only indoors
- The luminaire must not be covered with insulating material.
- The luminaire is not suitable for installation in the bathroom, at least not in the indicated area.a
- The luminaire is only suitable for wall mounting
- The luminaire is only suitable for ceiling mounting
- The luminaire is suitable for wall and ceiling mounting
- Strip the wire as indicated in the icon
- IP20: This product is intended for use in dry spaces indoors
- IP23: Rain resistant
- IP44: Splash proof. The product is protected against the intrusion of solid objects greater than 1 mm in size and water spray from any direction.
- IP54: Protected from limited dust ingress, protected from water spray from any direction.
- IP65: The product is dustproof and protected from water jets. The luminaire cannot be used if the housing is broken.
- This luminaire is (IP20) for components in the ceiling and (IP21) (IP23) (IP44) (IP65) for components under the ceiling, provided that this luminaire is installed correctly.
- If the protective glass is damaged, it must be replaced immediately.
- Always respect the minimum distance between the light source and the illuminated materials as indicated in the icon.
- Max. … W: Use only lamps of the correct type and never exceed the maximum indicated wattage.
Use a heat-resistant cable to connect the luminaire to the mains - This luminaire is only suitable for lamps with built-in protection or ‘low-pressure’ lamps.
An extra protective glass is not required. - The luminaire is equipped with a built-in fuse. If the luminaire does not work after replacing the lamp, this fuse must be replaced. If the fixed connection wiring of the installation can be touched, this may only be done by a qualified electrician.
- This luminaire is suitable for top-mirror lamps.
- The luminaire is only suitable for fixed mounting and must therefore not be connected to a power source by means of a connecting cord.
- Type X: If the external flexible cable or cord of this fixture is damaged, it will be replaced by a special cord or cord exclusively available from the manufacturer or its service agent.
- Type Y: If the external flexible cable or cord of this luminaire is damaged, it should only be replaced by the manufacturer or its service agent, or a similarly qualified person, in order to avoid a hazard.
- Type Z: the external flexible cable or cord of this luminaire cannot be replaced; If the cord is damaged, the fixture will be destroyed.
- Note that no electrical or other wires in the ceiling or wall are touched during the installation of this luminaire.
- Electrical installation wires must never be clamped or twisted (twisted) between the luminaire and the mounting surface.
- This product is dimmable and compatible with a TRIAC dimmer.
- This product uses LED technology and is only suitable for it.
- The light source of this luminaire is not replaceable; when the end of the service life has been reached, the entire luminaire must be replaced.
- Replaceable (LED only) light source by a professional
- This product must not be covered by objects.
- Keep this product away from sharp edges, oils, and heat.
- Never use this product in an area where there is a risk of explosion or near flammable substances or gases.
- If this product is passed on to third parties, manuals must be included.
- Keep this product out of the reach of children
- Turn off the product when you leave the room.
Conformity with all relevant EU Directive requirements
- Safety: if applicable, only use this device for its intended purpose; do not use this device if damaged or defective. If this product is damaged, especially if the cable or fitting is damaged, this product must be shut down immediately. In this case, replacement is required; before replacing, turn off the power and let the device cool to avoid electrical shock or burn. The adapter (if applicable) must be installed near the device, not connected to any other adapter, and easily accessible. Products may only be used in combination with the original adapter. This product should only be opened by an authorized technician when maintenance is required. Never carry out repairs yourself. To disconnect voltage: pull the plug.
Disposal, warranty, disclaime r,a nd intended use.
- Removal of your product. This product is made ofhigh-qualityy materials and parts that can be recycled. If you see this symbol on your product, it means that the product is covered by EU Directive 2002/96 / EC. Ask your own local government about the way in which electrical and electronic products are collected separately in your region. When disposing of old products, observe local legislation and do not dispose of these products in the normal household waste. Properly disposing of old products will prevent adverse effects on the environment and public health.
Warranty
- Any changes and/or modifications to the product will void the warranty. We cannot accept any liability for damage caused by incorrect use of the product. Disclaimer: designs and specifications might be subject to change without notice. All logos, brands, and used product references are trademarks or registered trademarks of their respective holders and hereby recognized as such.
FAQS
Q: What plugs and screws should I use for installation?
A: Before installing, check for the best-suited plugs and screws for the surface.
Q: Can I connect the product to a power supply while it is still packaged?
A: No, do not connect it to a power supply while in the package.
Q: Is the luminaire dimmable?
A: Yes, this product is dimmable and compatible with a TRIAC dimmer.
Documents / Resources
 |
CALEX 4301003103 Vista String Lights [pdf] Instruction Manual 4301003103, 4301003103 Vista String Lights, Vista String Lights, String Lights, Lights |