CAL-ROYAL ESC-45 Series Exit Devices
INSTRUCTIONS FOR ESC45 NARROW STILE
ESCUTCHEON LEVER TRIM
FUNCTION
NOTE: 03 & 08 function – Standard collar height fits 1 ¼” Mortise Cylinder only, other Mortise Cylinder height should use proper size collar.
INSTRUCTIONS FOR SETTING HAND OF LEVER
(EXAMPLE FOR RH)
Step 1.
Trim shipped with lever in the neutral (non-handed) position.
Step 2.
Rotate lever to desired hand. Insert two lever hex screws accordingly (not tighten yet).
Ensure the middle handed Phillips screw is tighten and then tighten two lever hex screws with hex wrench.
Step 3.
Install (2) thru-bolts. Insert spindle base on door thickness and fix set screw.
* Suitable for door thickness 1 ¾” ~ 2 ⅜” (45~60mm)
*After setting, please ensure the (2) lever handing screws are tighten to avoid lever operating problems.
Cylinder installation:
(follow 
* Standard collar height fits 1¼”~1 ⅜” mortise cylinder.
PARTS LIST
| No | Parts | Q’ty |
| 1 | Trim | 1 |
| 2 | Thru. bolts | 2 |
| 3 | 10#-24 Screw | 2 |
| 4 | Spindle | 1 |
| 5 | M5 screw | 2 |
| 6 | Washer | 2 |
| 7 | Allen Wrench | 1 |
| 8 | Instruction Guide | 1 |
| 9 | Template | 1 |
Documents / Resources
 |
CAL-ROYAL ESC-45 Series Exit Devices [pdf] Instruction Manual ESC-45 Series Exit Devices, ESC-45 Series, Exit Devices, Devices |