Informació important de seguretat
Please read all instructions carefully before using the DAYTECH DA10 Fridge and Freezer Door Alarm. Retain this manual for future reference.
- Aquest dispositiu només està dissenyat per a ús interior.
- No exposeu el dispositiu a temperatures extremes, llum solar directa ni humitat.
- Keep out of reach of children to prevent accidental ingestion of small parts or batteries.
- Ensure proper battery polarity when installing.
- Eliminar les bateries usades d'acord amb la normativa local.
Producte acabatview
The DAYTECH DA10 Fridge and Freezer Door Alarm is designed to alert users when a refrigerator or freezer door has been left open for a user-defined period, helping to prevent food spoilage and conserve energy.
Components
- Unitat principal: Contains the buzzer, LED indicator, and control buttons.
- Imant: A smaller component that interacts with the main unit to detect door status.
- Piles AAA: Two AAA batteries are required and included for operation.
- Cinta adhesiva: For secure, tool-free installation.
Característiques del dispositiu
- Retard ajustable: Set the alarm to trigger after 1, 2, 3, or 4 minutes.
- Two Tones: Choose between a gentle chime or a loud alarm sound.
- Volum ajustable: Five volume levels ranging from 0 dB (mute) to 120 dB.
- Avís de bateria baixa: The device will indicate when batteries need replacement.
Configuració i instal·lació
Instal·lació de la bateria
The device requires two AAA batteries for operation. These are included with your purchase.
- Locate the battery cover on the back of the main unit.
- Slide the cover open in the direction indicated by the 'OPEN' arrow.
- Introduïu dues piles AAA, assegurant-vos de la polaritat correcta (+/-).
- Feu lliscar la coberta de la bateria al seu lloc fins que faci un clic de manera segura.
Muntatge de l'alarma
The alarm can be installed on various doors, including refrigerators, freezers, cabinets, and windows, using the provided adhesive tape.
- Clean the surface where the main unit and magnet will be installed. Ensure it is dry and free of dust or grease.
- Peel off the protective film from the adhesive tape on the back of both the main unit and the magnet.
- Attach the main unit to the door frame or the fixed part of the appliance.
- Attach the magnet to the moving part of the door, ensuring it aligns with the triangular mark on the main unit.
- Important: The distance between the main unit and the magnet must be less than 0.98 inches (2.5 cm) when the door is closed for proper detection.
Guia de vídeo d'instal·lació
Instruccions de funcionament
Power On/Off and Tone Selection
The device features a single switch for power and tone selection.
- Feu lliscar el commutador a 'CHIME' for a gentle reminder tone.
- Feu lliscar el commutador a 'ALARM' for a loud, piercing alert.
- Feu lliscar el commutador a DESACTIVAT to power down the device.
Ajust de volum
The volume can be adjusted to suit your environment.
- Premeu el botó Botó de volum (located below the CHIME/ALARM/OFF switch) to cycle through 5 volume levels: 0 dB (mute), 30 dB, 60 dB, 90 dB, and 120 dB.
Setting Delay Mode
The alarm features four delay modes, allowing you to choose how long the door can remain open before an alert sounds.
- Premeu el botó Tecla SET (located at the bottom of the side panel) to cycle through the four available delay modes. Each press will advance to the next mode.
| Mode | Retard inicial | Alarm/Chime Frequency |
|---|---|---|
| 1 | 1 minut | Sound for 5 seconds every 15 seconds |
| 2 | 2 minuts | Sound for 10 seconds every 10 seconds |
| 3 | 3 minuts | Sound for 15 seconds every 5 seconds |
| 4 | 4 minuts | Sound for 20 seconds every 15 seconds |
Vídeo de demostració de l'operació
Manteniment
Canvi de bateria
When the low battery warning sounds (5 short beeps when the door is opened), it is time to replace the batteries.
- Slide the battery cover open on the main unit.
- Traieu les piles AAA velles.
- Insert two new AAA batteries, observing correct polarity.
- Tanqueu la tapa de la bateria amb seguretat.
Neteja
To clean the device, gently wipe the exterior with a dry, soft cloth. Do not use liquid cleaners or immerse the device in water.
Resolució de problemes
- L'alarma no sona: Ensure the device is powered on (not in 'OFF' mode). Check if the batteries are correctly installed and have sufficient charge. Verify that the main unit and magnet are properly aligned and within the 0.98-inch (2.5 cm) gap.
- Alarm too quiet or too loud: Adjust the volume using the volume button on the side of the main unit.
- Falses alarmes: Re-check the alignment and gap between the main unit and the magnet. Ensure they are securely attached and not shifting.
- Avís de bateria baixa: Substitueix les dues piles AAA per unes de noves.
Especificacions
- Model: DA10
- Font d'alimentació: 2 piles AAA (incloses)
- Voltage: 3 volts (CC)
- Mètode de control: Touch (for volume/mode), Slide Switch (for power/tone)
- Tipus de muntatge: Suport de porta (adhesiu)
- Tecnologia del sensor: Sensor de contacte
- Dimensions (Unitat principal): Aproximadament 3.9 x 1.6 x 0.86 polzades (100 x 40 x 22 mm)
- Pes de l'article: 7.2 unces
- Nivell de so: 0-120 dB (Adjustable)
- Modes de retard: 1, 2, 3, 4 minuts
- Color: Blanc
Garantia i Suport
For warranty information, technical support, or any inquiries regarding your DAYTECH DA10 Fridge and Freezer Door Alarm, please refer to the contact details provided on the product packaging or visit the official Daytech weblloc web. Conserveu el rebut de compra com a comprovant de compra per a reclamacions de garantia.
