C Crane VEC1 Home Long WiFi Receiver System
PRODUCT INFORMATION
The CC Vector WiFi Repeater is a device that helps boost your existing WiFi signal. It comes with a Super USB WiFi Antenna DX that needs to be mounted vertically. The device has a main USB connector that needs to be plugged into a USB port, while the secondary USB should be left unplugged.
PRODUCT USAGE INSTRUCTION
- Refer to the Quick Start Setup Guide for initial setup instructions.
- Mount the Super USB WiFi Antenna DX vertically for optimal signal strength.
- Add silicone grease to the connection between the Super USB WiFi Antenna DX and the CC Vector WiFi Repeater for additional weather protection.
- Plug in the Super USB WiFi Antenna DX tightly and fully to ensure a good connection.
- Plug the main USB connector into a USB port.
- Leave the secondary USB unplugged.
OVERVIEW
MOUNTING OPTIONS
- Suction Cups for Smooth Surfaces
- Slide suction cups onto antenna from top down.
- Slide suction cups onto antenna from top down.
- Cable Tie
- Place cable tie around pole or tree limb, and at narrowest part of antenna for best stability.
- Place cable tie around pole or tree limb, and at narrowest part of antenna for best stability.
- Hook and Loop Material
- Remove backing from hook and loop material and press into place on antenna and mounting surface.
- Remove backing from hook and loop material and press into place on antenna and mounting surface.
- Detachable Lanyard
Copyright @2022 by C. Crane, Fortuna, CA 95540 Phone: 1-800-522-8863 Web: crane.com All Rights Reserved. No part of this booklet may be reproduced in any form or means whatsoever without permission in writing from C. Crane.
Documents / Resources
 |
C Crane VEC1 Home Long WiFi Receiver System [pdf] Installation Guide VEC1, VEC1 Home Long WiFi Receiver System, Home Long WiFi Receiver System, Long WiFi Receiver System, WiFi Receiver System, Receiver System, System |