BURG sPinLock 200 Mechanical Code Lock Instruction Manual

BURG sPinLock 200 Mechanical Code Lock

General
The latest version of this guide is available at: www.burg.de

Important notes
Please observe all important notes and read the entire operating manual before starting the configuration.

OVERVIEW

Technical Data

Default Settings

Scope of Delivery

• 1x locking system
• 1x cam fixing screw1
• 1x M19 nut
• 1x cam type B

Optional Accessories

• Master key
• Anti-twist protection

1.  The use of a screw with a different length may cause damage to the lock.
2.  Mounting dimensions and templates (STEP files) for milling, punching or lasering can be requested from BURG.

Mounting dimensions 2

All dimensions are in millimeters

Product dimensions 2
All dimensions are in millimeters

Functional Description

Mode: multi-user authorization (multi-user mode)
This mode is suitable for changing user groups where the locker is only used temporarily or once, e.g. in a sports facility. Codes are valid for a single locking process and are deleted from the lock when the compartment is reopene k remains open  until a new code locks the lock again.

Master key
By using the master key, you can read the current code and reopen the lock (code finding).

Note
The master key is not included. If needed, it can be ordered separately.

Operation

Lock

1. Turn the knob to open position.
2. Set code.
3. Turn the knob to closed position.
4. Turn the number wheels to lock.

Unlock

1. Set current code
2. Turn the knob to open position.

Code finding via master key

1.  Insert the master key and turn it 90° to the right.
2. Turn the number wheels from top to bottom until each one locks into place. The valid code can then be read.
3. Turn the master key 90° to the left and remove it.
4. Turn the knob to open position

Assembly

Mounting dimensions and templates (STEP files) for milling, punching or lasering can be requested from BURG.

1. Prepare the mounting holes on the door front according to the installation dimensions (dimensions on p. 3).
2. Insert the lock from the front (outside of the door) into the mounting hole and hold it in this position. The lock must be straight and the BURG logo must be at the top.
3. Place the M19 nut on the stator from behind and tighten hand-tight using a socket wrench (SW22).
4. Attach the cam. Tighten it with the cam fixing screw by hand using a cross-head screwdriver (e.g., size PH 2).
   
5. Check whether the cam is securely held in place on the strike plate or rebate when closed. When closing the locking system, it should be possible to turn the cam to its end position without applying pressure or resistance.
   Note: An adjustable strike plate allows for optimal adjustment of the closing mechanism. More information can be requested from BURG.

Guarantee and Warranty

The warranty is subject to the statutory provisions. If you have any questions, please contact a specialist dealer or use the contact details below.