BNETA F14-L Automatic Pet Feeder

FEATURES

SETUP AND ASSEMBLE FEEDER

Lift The Latch
Take out the food hopper and install it by aligning the slot on the base.

Place Desiccant
Open the desiccant box on top lid, tear off the transparent wrapping paper of the desiccant bag, place it into the box and close it.

Plug-in Power Adapter

• Battery power supply: remove the battery cover by releasing the retaining clip, insert 3 good quality alkaline “D” batteries and reinstall the battery cover.
• Power adapter supply: plug in the power adapter and connect the power cable into the card slot.

Note: Please use safe and standard alkaline batteries. Do not mix batteries of different specifications and models.

Install Food Bowl
Tilt the base unit back slightly, align the buckle of the food bowl with the base unit to install; the same steps to disassemble.

Fill Pet Food
pen the top lid, pour fresh dry food into the food hopper, and close the top lid.
Note: The device only support 5-12mm dry pet food.

PRODUCT INTRODUCTION

Unlock the Panel
Long press “” button for 5 seconds to unlock, 30 seconds no operation screen will be automatically locked.

Set Clock

1. Unlock the panel, Press “” button to enter setting.
2. SetClock: Press “” or “” to adjust hours, Press “” button to confirm. Press “” or “” to adjust minutes Press “” button to confirm.

Program Feeding Schedule

1. Program Meal Time: “1” icon flash means setting the first meal, Press “” or “” to adjust hours and minutes, Press “” button to confirm.
2. Meal Size: LCD display goes into meal size set mode after setting the meal time “” icon illuminate, Press “” or “” to select desired, Press “” button to confirm.
3. Repeat this process for as meal times portions desired (Up to 4 meals and 9 portions).
4. If you do not need to set too much feeding schedules, long press the “” button to save and exit the set mode.

Check the feeding schedule
In the locked state, press “” or “” to check the 1-4 meal feeding schedule, but it cannot be set.

Manual Feed
Unlock the panel, long press “” button to feed one.

Record
Unlock the panel, long press “” to enter recording mode, the “STATE” indicator light is on and record voice toward the “MIC” hole for up to 10 seconds. If the “” button is released with in 10 seconds, the recording ends immediately.
*Note: If you need to record again, repeat the above steps.

Play Record
Unlock the panel, press “” to play record once, no play if no record.

Cancel Feeding Schedule
Set the portion to be “PORTION: “, then no feed anymore.

Default Meal Settings
Unlock the panel and press the “” and “” simultaneously until heard “DiDi” sound, which reset the time and clears the feeding schedule and recording.

Indicator Information

LCD Screen Icons Information

DISASSEMBLE & CLEAN

Power Off
Unplug and take out the alkaline batteries.

Clean

1. Hold the fuselage steady and pull out the food hopper upward.
2. Disassemble the impeller and feeding mechanism.
3. The main body of the feeder is not dishwasher-safe. Do not immerse the main body in water. This could damage the internal electronics and cause the batteries to short out, create an electrical shock, or catch fire.
4. Use a dry soft cloth to wipe it, the body is not waterproof, please do not use wet cloth.
5. Make sure all parts of the feeder are completely clean and dry before filling with food.

Assemble

1. Align the triangle mark when installing the impeller.
2. Install the food hopper by aligning the slot on the base.

Replace the Desiccant Pack
Open the desiccant box cover and replace the desiccant. It is suggested to replace it once every month.

Replace Alkaline Batteries
Unplug and open the battery lid at the bottom, then you can replace the batteries.

Warnings

• Keep the food hopper dry after cleaning it.
• Replace the food regularly if your pets did not finish their food.
• Clean and maintain your device regularly to prolong the life of your pet feeder.

TROUBLESHOOTING

PARAMETERS

SAFETY PRECAUTIONS

Read all instructions carefully before attempting to operate this device.

Keep Device

1. For indoor use ONLY.
2. Device must be placed horizontally and stable. Device must not be tipped, rocked, or placed upside down.
3. Keep device placed in a dry area and do not expose to sunlight.
4. Do not place the feeder in a high place to avoid the damage from dropping.
5. Do not place any foreign objects in the feeder.
6. To avoid tripping, always keep power cord out of the way of foot traffic.
7. Do not place anything on top of the feeder.
8. Ensure there are no barriers near the food outlet to ensure that pets can be fed normally.

Electrical Safety

1. Please check the power supply before going out.
2. The clock will be maintained for a year if the device is powered off.
3. Please pay attention to the battery display when powered by batteries, users need to replace the batteries when “” shows on LCD screen.
4. If you do not operate the feeder with electrical power, it is recommended that your replace the batteries once a year to ensure a functional backup when required
5. When powered by batteries, it is normal for the electric quantity icon to fluctuate occasionally because of the large transient current.
6. To prevent electric shock, do not insert the power cord or plug into water or other liquids.
7. The device only supports the use of a 5V/1A adapter; please do not use a non-specific adapter.

Caution

1. Intended for use with dogs or cats ONLY.
2. DO NOT use this feeder with puppies, kittens, dogs or cats with any physical disability.
3. NOT recommended for puppies or kittens less than 7 months old or unable to reach the feeding dish.
4. DO NOT allow small children to play with, in or around feeder.
5. DO NOT eat the desiccant. DO NOT use it if it is damaged.
6. For dry food use ONLY. Works best with 5- 12mm food diameter or smaller.
7. DO NOT attempt any repairs or modifications to the feeder.
8. To avoid damage to electric components, DO NOT immerse the feeder in water at any time.
9. Avoid any chances of suffocation from packaging bags and be sure to dispose of all packaging material properly. Keep away from both children and pets.
10. Check with your veterinarian if you are unsure about the proper MEAL SIZE for your pet.
11. DO NOT operate feeder without Bowl. Food Hopper and Lid securely in place.

BNETA International
sales@bneta.co.za
www.bneta.co.za

Documents / Resources

BNETA F14-L Automatic Pet Feeder [pdf] User Manual F14-L Automatic Pet Feeder, F14-L, Automatic Pet Feeder, Pet Feeder, Feeder

References

• User Manual