ZMLH-T5 Al Intelligent Scalp Analyzer
“
Product Information
Specifications:
- Compliance: Part 15 of FCC Rules
- RF Exposure Requirement: General RF exposure requirement
- Radiation Exposure Limits: FCC radiation exposure limits for an
uncontrolled environment - Minimum Distance: 20cm between the radiator and the body
Product Usage Instructions
Installation:
- Ensure the device is placed at least 20cm away from your
body. - Connect the device to a power source as per the manufacturer’s
instructions. - Follow any additional installation guidelines provided by the
manufacturer.
Operation:
- Operate the device within the specified RF exposure
limits. - Avoid making any changes or modifications to the device that
are not approved by the manufacturer. - If the device causes interference, try adjusting its placement
or contact the manufacturer for assistance.
Maintenance:
- Regularly clean the device as per the manufacturer’s
recommendations. - Check for any signs of damage and address them promptly.
- Keep the device away from water or extreme temperatures to
ensure proper functioning.
FAQ
Q: Can I modify the device without voiding the warranty?
A: Any changes or modifications not approved by the manufacturer
may void your warranty. It is recommended to contact the
manufacturer for guidance on modifications.
Q: What should I do if the device is causing interference?
A: Try adjusting the placement of the device to minimize
interference. If the issue persists, contact the manufacturer for
further assistance.
“`
FCC warning statements:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Documents / Resources
 |
Bitmoji ZMLH-T5 Al Intelligent Scalp Analyzer [pdf] User Manual ZMLH-T5, 2BGPD-ZMLH-T5, 2BGPDZMLHT5, ZMLH-T5 Al Intelligent Scalp Analyzer, ZMLH-T5 Al, Intelligent Scalp Analyzer, Scalp Analyzer, Analyzer |