BITIWEND B8WET01 Wireless Signal Forwarding Extension Set

BITIWEND B8WET01 Wireless Signal Forwarding Extension Set

Overview

  1. Plug-in Receiver
    Overview
  2. Transmitter
    Overview

Two Modes of Transmitter

Mode switching via internal dip switches
Two Modes of Transmitter
MODE 1
Short-circuit Trigger Mode: When selected, the two external wires can be connected to the two terminals of the output switch signal without polarity distinction. For example: connect the two directly to the two ends of the switch, when the switch is pressed the product transmits a wireless signal and the indicator light is on.
Two Modes of Transmitter
MODE 2
AC/DC Input Mode
  1. AC Input:
    The two wires can be directly connected to the AC terminals without distinguishing polarity.
    Input voltage range: AC 3-24V.
  2. DC Input:
    Polarity must be observed – connect the red wire to the positive (+) terminal and the black wire to the negative (-) terminal. Input voltage range: DC 5-32V.
    When the two wires are connected to 3~24VAC or 5~32VDC, the product will emit wireless signal and the light will be on.
    Tip: Tip: The optimal trigger signal duration is typically around 1 second. This product features an 8-second maximum emission protection mechanism. When the trigger duration exceeds 8 seconds, the device will automatically cease operation, halt signal transmission, and deactivate its indicator light. Signal emission will only reesume upon re-triggering.
    Two Modes of Transmitter

Pairing & Reset

  1. Reset – Plug the receiver into the socket, Long Press the Down(Music) Button on the receiver for about 5 seconds, Restore the factory settings at first ;
  2. Pairing – Choose favourite music and Long Press the Volume Button for about 5 seconds until the receiver “ding” with the indicator blinking rapidly, setting the receiver into pairing mode;
  3. Quickly press the push button to activate the transmitter to send a signal to the rec

Symbol Child Safety Warning

WARNING: This product contains small parts and is not suitable for children under 3 years old, as it may cause choking.
Do not allow children to operate this device alone; it must be used under adult supervision.

Battery Disposal Warning (if applicable):
Please dispose of used batteries properly in accordance with local regulations. Do not throw them into fire or dismantle them.
WARNING: Batteries may pose an explosion risk; they must be installed and used correctly.

Usage Warning:
Please strictly follow the instructions in the manual; improper use may cause injury.
Do not attempt to repair this product yourself; all repairs should be carried out by authorized personnel.

Electric Shock Risk Warning:
WARNING: To avoid electric shock, do not expose this product to rain or a damp environment.
This device is for indoor use only; keep it away from water sources and high humidity areas.

Product Recycling:
Do not dispose of this product carelessly; follow local waste disposal regulations.

Documents / Resources

BITIWEND B8WET01 Wireless Signal Forwarding Extension Set [pdf] Instruction Manual
B8WET01 Wireless Signal Forwarding Extension Set, B8WET01, Wireless Signal Forwarding Extension Set, Signal Forwarding Extension Set, Forwarding Extension Set, Extension Set

References

Leave a comment

Your email address will not be published. Required fields are marked *